ADTRAN netvanta 1230 series Manuals

NetVanta 1230 Series Hardware Installation Guide 1700594G1 NetVanta 1234 1700595G1 NetVanta 1234 PoE 1700598G1 NetVanta 1238 1700599G1 NetVanta 1238 PoE 61700594G1-34B July 2009

Quick Start Guide, 61700594G1-13B, November 2011 1 NETVANTA 1230 SERIES FAST ETHERNET SWITCH P/N 1700594G1, 1700595G1, 1700598G1, 1700599G1, 1700599G2 ed. GETTING STARTED Two configuration methods are available for your NetVanta unit: • Web-based graphical user interface (GUI) • ADTRAN Operating System (AOS) command line interface (CLI) The GUI lets you configure the main unit settings and provides online guidance and explanations for each setting. However, using the AOS CLI may be necessary for more advanced configurations. ACCESS THE GUI You can access the GUI from any Web browser on your network by following these steps: 1. Connect the unit to your PC using any Ethernet switchport on the front of the unit and an Ethernet cable. 2. Set your PC to a fixed IP address of 10.10.10.2. To change your PC’s IP address, navigate to Computer > Control Panel > Network Connections > Local Area Connection > Properties > IP (TCP/IP) and select Use this IP Address. Enter these parameters: IP Address: 10.10.10.2 Subnet Mask: 255.255.255.0 Default Gateway: 10.10.10.1 You do not need to enter any domain naming system (DNS) server information. After the information is entered, select Ok twice, and close the Network Connections dialog box. If you cannot change the PC’s IP address, you will need to change the unit’s IP address using the CLI. (Refer to the next two sections for instructions.) 3. Open a Web browser and enter the unit’s IP address in your browser address line as follows: http://10.10.10.1. The default IP address is 10.10.10.1, but if you had to change the unit’s IP address using the CLI, enter that address in the browser line. 4. You will then be prompted for the user name and password (the default settings are admin and password). 5. The initial GUI screen appears. You can access initial setup information by selecting Setup Wizard from the menu on the left. ACCESS THE CLI Access the AOS CLI via the CONSOLE port or a Telnet session. To establish a connection to the NetVanta unit CONSOLE port, you need the following items: • PC with VT100 terminal emulation software • Straight-through serial cable with a DB-9 (male) connector on one end and the appropriate interface for your terminal or PC communication port on the other end You can find VT100 terminal emulation software on most PCs by navigating to Start > Programs > Accessories > Communications > HyperTerminal > HyperTerminal. When you have opened a HyperTerminal session, enter the settings described in Step 4. N’s se To on N’s S

NetVanta 1230 Series Fast Ethernet Switch Hardware Installation Guide 1703594G1 NetVanta 1234 1703595G1 NetVanta 1234P 1702599G1 NetVanta 1238P 61702594G1-34D July 2014