AEM 21-718 Manuals

Equipped with AEM Dryflow  Filter No Oil Required! INSTALLATION INSTRUCTIONS AEM Induction Systems 1 (800) 992-3000 WWW: http://www.aemintakes.com *NOTE: Legal in California only for racing vehicles which may never be used upon a highway PART NUMBER: 21-718 2012-13 HYUNDAI ELANTRA 1.8L SEE*NOTE 2 PARTS LIST Description Qty. Part Number A TUBE, INTAKE, 2012 HYUNDAI ELANTRA 1.8L 1 2-1496 B MOUNT, INSULATED, M6 X 0.625 1 1228598 C WASHER, FLAT, M6 X 1.0 DIA. 1 08160 D NUT, HEX, FLANGED M6-1.0 1 444.460.04 E HOSE, COUPLER, SILICONE 2.75” DIA X 3.0 1 5-275 F 1/2” BNDHOSE CLAMP, #48, 2.56”-3.50” DIA. 3 9444 G AIR FILTER ELEMENT ASSY. 2.75 X 5.0” OFFSET 1 21-202DOSK 3 Read and understand these instructions BEFORE attempting to install this product. Failure to follow installation instructions and not using the provided hardware may damage the intake tube, throttle body and engine. The AEMintake system is a performance product that can be used safely during mild weather conditions. During harsh and inclement weather conditions, you must return your vehicle to stock OEM airbox and intake tract configuration. Failure to follow these instructions will void your warranty. 1. Preparing Vehicle a. Make sure vehicle is parked on a level surface. b. Set parking brake. c. If engine has run in the past two hours, let it cool down. d. Disconnect negative battery terminal. e. Do not discard stock components after removal of the factory system. A. Open vehicle hood. Remove the plastic engine cover. B. Disconnect the breather return hose at the stock intake tube. 2. Removal of stock system C. Disconnect PCV hose on top of the valve cover and pull it aside to expose the hose clamp at the throttle body below. D. Loosen the hose clamp at the throttle body. 4 E. Unfasten the airbox clamps and remove the stock airbox lid and intake tube. I. Using a #2 Phillips screwdriver, unscrew the 2 plastic clips retaining the plastic underside brush guard to the front bumper on the driver’s side, then remove the clips. F. Remove the stock air filter. Do not discard. G. Remove the 3 M6 mounting bolts with a 10mm socket. Slide the lower airbox housing to the left and remove it from the engine bay. H. Depress the center buttons of the two plastic clips retaining the stock intake scoop to the radia- tor support. Pull up on the clips to remove them, then remove the stock intake scoop. J. Raise the vehicle safely and remove the left front (driver’s side) wheel. Make sure to set the parking brake, chock the rear wheels, and use proper jack stands before working under the vehicle.