AEM 21-814C Manuals

1 Equipped with AEM® Dryflow™ Filter No Oil Required! INSTALLATION INSTRUCTIONS PART NUMBER 21-814C (GUN METAL GRAY FINISH) 2017-18 TOYOTA COROLLA 1.8L 2 ITEM NO. PART NUMBER DESCRIPTION QTY. 1 21-2127DK AIR FILTER; 2-3/4" X 5" OVAL DRYFLOW 1 2 2-1597C Tube; 2.50” X 32” L, 2017 Toyota Corolla 1 3 084018 Hose; 2.50”ID x 2.50” L Hump Reinforced 1 4 8-197-1 Extension Harness; 5 Pin 18” Denso 1 5 9440 Hose Clamp; 2.15”-3.00” 2 6 9448 Hose Clamp; 2.56”-3.50” 1 7 07733 Bolt; M4x.07 8mm, A/H Cap , SS 2 8 1228599 Mount, Rubber 1” x 6mm 1 9 444.460.04 Nut; M6 Hex Serrated 1 10 08160 Washer; 1”D x .25” Hole Fender 1 11 1-127 Zip Tie; 8” Tree Push Mount 1 3 Read and understand these instructions BEFORE attempting to install this product. Failure to follow installation instructions and not using the provided hardware may damage the intake tube, throttle body and engine. If you need any assistance please call1-800-858-3333 to speak with a representative in our Customer Service Center before returning the product. 1. Preparing Vehicle a. Make sure vehicle is parked on level surface. b. Set the parking brake. c. If engine has run in the past two hours, let it cool down. d. Disconnect negative battery terminal. e. Do not discard stock components after removal of the factory system. f. Open the air intake kit package and make sure all parts are included. 2. Removal of stock system a. Pull up on engine cover to remove from rubber grommets. b. Disconnect both battery terminals, remove bolt that holds battery strap, then remove battery from vehicle. c. Unplug the Mass Air Flow sensor electrical connector. d. Remove the 4 bolts that hold the battery tray, the bolt for the ground cable to chassis, and the one bolt for the air box scoop. BOLTS WILL BE REUSED IN STEP 3d. Tools Needed: Screwdriver 8, 10mm Socket Socket Driver Pliers 4mm Hex Key Floor Jack Jack Stands