Altronix MOM5 Manuals

Sub-Assembly Installation Guide for Models: ACM4 ACM4CB ACM8 ACM8CB MOM5 PD4UL PD4ULCB PD8UL PD8ULCB PD16W PD16WCB PDS8 PDS8CB ACMS8 ACMS8CB VR6 LINQ2 LINQ8PD* LINQ8PDCB* *not evaluated by UL SIGNALING More than just power.TM Rev. MS020119 all-guide s.com

Overview: The MOM5 multi output power distribution module converts one (1) non-power limited DC voltage input to five (5) power limited outputs. Each output will route power to a variety of access control hardware and devices which includes Mag Locks, Electric Strikes, Magnetic Door Holders, etc... These outputs will operate in both fail-safe and fail-secure modes. Controlled trigger input is achieved through normally open (N.O.) or normally closed (N.C.) supervised input or the polarity reversal from an FACP (Fire Alarm Control Panel). A form “C” dry output relay will enable HVAC Shutdown, Elevator Recall or trigger auxiliary devices. Specifications: • NFPA72 compliant. • Class 2 outputs. • 12VDC or 24VDC Operation. • Five (5) individual power limited outputs. • Current limit is 2.5 amps @ 12VDC or 24VDC per output. • Fire Alarm Panel or Access Control System trigger inputs. (N.O. or N.C. supervised trigger input and polarity reversal trigger input). • Red LED’s indicate condition of each power output. • Power & input trigger LED’s. • Power fail supervision relay (Form “C” contact rated 1 amp @ 28VDC/115VAC). • Output relay indicates that unit is triggered. (Form “C” contact rated 1 amp @ 28VDC/115VAC). • Interfaces with most DC Power Supplies. • UL Listed for use with AL300ULX, AL400ULX & AL600ULX Power Supplies. Board Dimensions: 5.25”L x 3.5”W x 1”H Installation Instructions: 1. Connect the DC of the power supply to the terminals marked [- DC input +] carefully observing polarity. 2. Connect door strikes (fail-secure) positive to terminals marked [1 thru 5 Pos. (+) DC Output (Alarm)] and negative to [NEG. 1’ thru ‘NEG. 5]. 3. Connect door holders (fail-safe) positive to terminals marked [6 thru 10 Pos. (+) DC Output (Stand-by)] and negative to [NEG. 1’ thru NEG. 5]. 4. To trigger the MOM5 from a FACP connect signaling circuit of FACP to inputs marked [NEG. (-)] and [POS. (+)] input. Polarity is shown in alarm condition. Put wires coming to each terminal on different sides of the screw. 5. To trigger the MOM5 using a supervised dry contact connect the 2.2K resistor in series for a N.C. trigger input and in parallel for N.O. trigger input. 6. Connect the auxiliary devices that are to be triggered by the MOM5 to the terminals marked [N.O. & C] for nomrally open outputs and terminals marked N.C. & C for normally closed output. Note: This relay will energize when the MOM5 is triggered. 7. Connect trouble reporting device to the terminals marked [Power Fail]. Connect to the N.O. & C for normally open and N.C. & C for normally closed output. Note: This relay will switch when power is lost to the MOM5. MOM5 - Multi Output Power Distribution Module for Access Control