Arbiter Systems 1094B Manuals

MODEL 1094B GPS SUBSTATION CLOCK OPERATION MANUAL ARBITER SYSTEMS, INC. PASO ROBLES, CA 93446 U.S.A. WWW.ARBITER.COM

1094B SETUP GUIDE Unpacking Carefully check the packing material for these accessories: GNSS antenna, standard antenna cable assembly, and two rack-mount ears. Handle the GNSS antenna with care. It may be damaged if dropped. Configuring Output Jumpers Remove the four M5×10 mm pan head screws securing the clock cover. Some output signals require two jumpers. Example: 5 volt CMOS level IRIG-B Unmodulated on Output 1 requires JMP10=A and JMP11=C. Whereas IRIG-B Modulated on Output 1 only requires that JMP11=B. Figure 1: Mainboard Jumper Locations Output 1 Output 2 Output 3 Output 4 RELAY Drive Type JMP11 JMP13 JMP15 JMP17 CMOS, 5 V C* C* C* C* 300-V FET A A A A Signal Select JMP10 JMP12 JMP14 JMP16 JMP8 IRIG-B Modulated B B B B IRIG-B Unmodulated A* A* A* A* 1 PPS B B B B Programmable Pulse A C C C Programmable Pulse B C C Out of Lock A* Fault B * Default Setting Table 1: Mainboard Output and Relay Signal Selection Arbiter Systems, Inc. · 1324 Vendels Circle, Suite 121 · Paso Robles, CA 93446 · USA · Tel: +1.805.237.3831 Fax: +1.805.238.5717 · E-mail: [email protected] · Internet: http://www.arbiter.com PD0052800B 1