Arjohuntleigh Auralis Manuals

15 min Auralis 2s 1 Assemble seat cushion and pump Start the Auralis system 2 When the pump is connected to a power source it runs a self check: Beep - 10 seconds - 2 beeps - ready to use. Press and hold Run/Standby button. The following indicators are shown: • Run/Standby • Wait indicator • Alternating mode button • Comfort control indicator • Battery charge indicator • Green indicators on the front of the pump Once the Wait indicator turns off, place bed sheet on mattress. Make sure that the CPR rapid deflation unit is clearly visible. Place patient on the mattress or seat cushion. Alternating mode is set by default. Assemble mattress overlay or mattress replacement and pump CPR unit is clicked into closed position. “Click” 3 Connect the tubeset. Zip the protective cover over the mattress. Arjo logo visible at the foot end. Auralis 2 Mattress overlay: Place on top of base mattress. Secure with 4 fixing straps. Mattress replacement: Place on bed base. Attach the 8 securing straps to moving parts of bed frame. • tubeset at foot end • CPR at head end • cells facing up 1 4 5 6 Hang the pump at the foot end of the bed. Place cable in the cable management. Close the flap around the cable with the press studs. Connect power cable to power source. “Click” Seat cushion: Place on chair surface. Use the fixing straps to attach. Place pump on floor, cable under chair, tubeset placed alongside chair. Connect the tubeset. Connect power cable to power source. 2 1 • cells facing up • tubeset at front right corner • cells horizontal across chair, V-shape towards front Front of chair Back of chair “Click” 08.AI.02EN_01 • 06/2020 • Page 1/2 QUICK REFERENCE GUIDE - USE Auralis