Artecta Ribbon Series Manuals

2 1 1. Product Description 2. Safety Instructions Important Read and follow the instructions in this user manual before installing, operating or servicing this product. User Manual The Ribbon Series are IP20 LED strips for indoor installation at dry places. They are suitable for mounting in an aluminum prole. The Ribbon Series are available in various color temperatures and as RGB, RGBW and RGBA options. For complete product specications visit the respective product page on our website . www.highlite.com Ribbon Series This product must be installed in accordance with the applicable national and international standards for electrical installations. Improper installation may lead to hazardous situations and material damage. DANGER Installation, service and maintenance of this product shall be carried out only by qualied persons. 3. Installation Site Requirements Attention The LED strips are suitable for installation only in dry locations. Not suitable for outdoor installation. Do not install the LED strips: in wet locations at a place where the LED chips are exposed to direct sunlight near heat-generating devices. Do not install the LED strips in environments with highly volatile substances, such as sulfur, chlorine, bromine and VOC. This will reduce the life of the LED chips. Make sure that the LED strips are installed at a place with: ambient temperature between -20 °C and 50 °C sufcient airow. Make sure that the mounting surface is clean and smooth, and free of grease or silicone oil. Make sure that the mounting surface is thermally conductive and provides good heat dissipation. If the LED strips are mounted on a metallic surface, make sure that the soldering points are insulated. If the soldering points are not insulated, short-circuit may occur. ©2021 Artecta. All rights reserved. No part of this document may be copied, published or otherwise reproduced without the prior written consent of Highlite International. Design and product specications are subject to change without prior notice. For the latest version of this document and other language versions, please visit our website or www.highlite.com contact us at . [email protected] Highlite International B.V. • Vestastraat 2 • 6468 EX • Kerkrade • the Netherlands 4. Handling Do not connect the LED strip to electrical power supply when the LED strip is on the reel or when it is tightly coiled. This will damage the LEDs. Do not put excessive pressure on the LED chips. Do not fold or break the LED strips. Do not cover the LED strips with any material during operation. You can bend the LED strip only along the vertical axis. The minimum bending radius is 20 mm. Do not bend the LED strip with the LEDs on the inside. 20 mm Do not bend the LED strip on the horizontal plane. Do not twist the LED strip. It is recommended to install the LED strips in an aluminum prole. An aluminum prole provides good heat dissipation. V1