Atom HOVER Manuals

This product may contain substances that can be hazardous to the environment if not disposed of properly. Electrical and electronic equipment should never be disposed of with general household waste but must be separated of it’s correct treatment and recovery. Where possible recycle your packaging. Please keep these instructions safe for future reference. 120W, 150W and 200W IP65 LED Highbay. INSTALLATION SHEET LED highbay HOVER Product Range safety INFORMATION •� Luminaires�must�be�installed�and�fitted�by�a�qualified�electrician� ensuring the installation complies to the current wiring regulations. •� Always�switch�off�the�mains�supply�before�installation�or�servicing. • Ensure all electrical connections are secure and that there are no loose strands. •� If�the�external�flexible�cable�or�cord�of�this�luminaire�is�damaged,� it�shall�be�exclusively�replaced�by�the�manufacturer�or�his�service� agent�or�a�similar�qualified�person�in�order�to�avoid�a�hazard •� The�light�source�of�this�luminaire�is�not�replaceable;�when�the�light� source�reaches�its�end�of�life�the�whole�luminaire�shall�be�replaced. •� The�Atom�High�Bay�light�is�supplied�with�a�Ø25mm�steel�eye-bolt� specifically�provided�for�suspended�installation.�DO�NOT�substitute� the�eye-bolt�with�any�other�fitting�as�this�eye-bolt�has�been�tested�to� safely�bear�the�weight�of�the�light. •� WARNING:�CAUTION�-�RISK�OF�ELECTRICAL�SHOCK Product�Specification Voltage 220-240V~50Hz Power consumption 120W 150W 200W Light colour options Daylight Lumen output 16255lm 21425lm 27560lm Colour�temperature 5000K Colour�rendering�index >80 Beam angle 120° Dimmable 1-10V Dimmable Warranty 5 Years Working temperature -30°C – 45°C IP Rating IP65 Electrical�classification Class I Flex�and�plug�length 1.5m Installation The Atom High Bay light is supplied with an SS304 grade Ø25mm steel eye-bolt specifically provided for suspended installation. DO NOT substitute the eye-bolt with any other fitting as this eye-bolt has been tested to safely bear the weight of the light. 1. Remove the light from it's packaging and inspect for any signs of damage, particularly to the supplied flex and plug. Should any damage be visible, immediately return the product to place of purchase. DO NOT dismantle the light or attempt to repair. 2. Select installation point on ceiling or overhead support structure and securely mechanically fix suspension chain/rod/wire. The use of adhesives or double-sided tape is NOT recommended. DO NOT SUSPEND THE FITTING VIA THE MAINS CABLE. Ensure that, once installed the mains cable can comfortably reach the mains power outlet without any tension on the cable. 3. Attach fitting to end of suspension chain/rod/wire with the eye-bolt and plug mains cable into power outlet. The High Bay light is ready for use. 1-10V�Dimming An extra connection cable is provided on your highbay driver for interface of a 1-10V dimming signal from a control system or sensor. When not in use, cable should be left secured in place. Inspect for any signs of damage Particularly to the supplied mains cable 1 2 Select installation point and securely mechanically fix suspension chain/rod/wire 3 Attach fitting and plug mains cable into power outlet Model SKU Wattage HOVER/16022 16022 120W HOVER/16023 16023 150W HOVER/16024 16024 200W 172mm 53mm Ø239 174mm 55mm Ø271 Dimmable blue brown purple white DIM+ white blue gray black DIM-