Audiovox 50-0301x-002 SERIES Manuals

INSTALLATION INSTRUCTIONS FOR 50-0301x-002 SERIES 1181334 50-0301x-014 SERIES 1181332 50-0301x-019 SERIES 1181336 FORD EXPLORER / MERCURY MOUNTAINEER VCP HOUSING These instructions are intended for use only by experienced professionals in the automotive customizing business. Special tools and equipment, as well as specialized handling and care of product during installation, may be required. Before beginning this installation, carefully read through the following instructions. Check for wiring or other componentry behind VCP area before installing. Materials/ Tools required for this installation: 1. #2 Phillips screwdriver 2. Powered screwdriver or drill with adapter 3. Awl or similar tool 4. Razor knife or similar 5. Audiovox VCP (AVP-7180 or equiv.) Nov. 8, 1999 Printed in the U.S.A INSTALLATION INSTRUCTION # 44-0040A 2 MATERIALS PROVIDED FOR INSTALLATION: ITEM Description QTY 1 SCREW, # 8X 9/16" PWH 10 1 2 SCREW, # 8 X 3/4" PPH 2 2 3 VCP MOUNTING BRACKET 1 4 VCP HOUSING 1 5 FOAM TAPE, 3/4" X 3/4" X 14" 2 INSTALLATION INSTRUCTION # 44-0040A Nov. 8, 1999 Printed in the U.S.A. 3 I. PREPARATION OF VEHICLE INTERIOR 1. Retract storage cover, remove from location and lay it in a safe place. See Figure 1. 2. Fold rear seat forward. 3. Install and route all video and audio cables, and any other added component requirements to their respective places in the vehicle. Refer to component installation instructions for wiring diagrams. The suggested routing of the video system cable is as follows: Above the headliner from video system to C-pillar. Down the C-pillar to the floor. Route the power lead to a fused accessory controlled source. Connect the ground lead to the vehicle chassis. Route the remaining wiring (RCA plugs, Remote Sensor extension, etc.) to the VCP location. See Figure 2. Connect per instructions included with the video system. If video system if to be used as a television, install an appropriate antenna per instructions included with the antenna. II. INSTALLATION OF HOUSING 4. Remove and retain (2) two # 8 X 9/16" screws (item 1 pg 2 ) from VCP housing assembly. Separate VCP housing (item 4 pg 2) from mounting bracket (item 3 pg 2). Install mounting bracket as shown in Fig. 3. Secure using (8) eight # 8 X 9/16" screws (item 1 pg 2). Do not overtighten screws. FIGURE 1 FIGURE 2 FIGURE 3 4 5. Remove and discard (2) two screws from the left side of VCP. See Figure 4. 6. Insert VCP into mounting bracket (item 3 pg 2) as shown in Figure 5. Route wiring through opening in VCP bracket. Connect all wiring to VCP per instructions included with video system. 7. Check function of all components. See operating instruction for video system operations check. For further assistance, refer to the video system manual for the technical support phone number listed for your area. 8. Secure VCP to mounting bracket using (2) two # 8 X 3/4" screws (item 2 pg 2) into original holes in VCP. Do not overtighten screws. See Fig. 5. 9. Place VCP housing (item 4 pg 2) over VCP. Lightly mark the location where housing mates to side panel. Remove VCP housing. FIGURE 4 FIGURE 5 FIGURE 6