Auralex Acoustics Elite Pro Systems EPS-168T Manuals

Installation Guidelines Thank you for Purchasing Auralex ® Total Sound Control ® Products! Elite Pro System EPS-168T Components Congratulations on purchasing an EPS-168T™ System from Auralex® Acoustics. You’re now on your way to creating a world class listening environment. Elite Pro Systems offer a sophisticated look by utilizing products covered with specialized acoustical fabrics. The EPS-168T system contains B22 ProPanels™, CT45 Bass Traps™ and ProFusors™, which when used together, provide incredibly effective acoustical control in any room. Use the EPS-168T alone for treatment of small to medium-sized rooms or in combination with other Auralex products for full control of larger spaces. B22 ProPanels™ 20 Impaling Clips 80 CT45 Bass Traps™ 8 Elite Pro Systems ™ EPS-168T ProFusors™ 6 Z-Clips 48 Tubetak Pro™ 2 845-606 | Rev. 1 | 070506 EF Recommended Additional Installation Materials • Power Drill • Tape measure • Carpenters Level • Small ladder (depending on ceiling height) • Nail Set • Hammer • Pencil • 32 2.5” 4D finish nails • Straight Edge • 256 .75”-1” drywall screws Elite Pro System EPS-168T General Information B22 ProPanel Installation Guide ➋ Install four impaling clips within marked B22 ProPanel location using drywall screws. Exact placement of each clip is not necessary. ➊ Mark intended location of each B22 ProPanel on the wall or ceiling. Marked panel outline ➌ Start the B22 ProPanel 5/8” above its intended final height and press downward at a 45° angle until the panel is flush with the wall surface. TIP For permanent mounting, apply Tubetak Pro adhesive to the back of the B22 ProPanel before completing Step 3. CAUTION Always use Tubetak Pro on the back of the panel when attaching it to the ceiling. CT45 Bass Trap Installation Guide 16.75” ➊ Mark a vertical line 16.75” from the intended placement corner on both sides. ➋ Hold CT45 Bass Trap in corner with edges aligned to the marked vertical lines. ➌ While continuing to hold panel in place, install one finish nail though the fabric face and the hardened edge of the CT45. Make sure finish nail is installed perpendicular to the wall surface. Repeat in each of the four corners. ➍ Using a nail set or other finish nail, carefully countersink installed nail so its head goes through the fabric surface of the CT45 but not through the hardened edge. ➎ Once finish nail has been countersunk into the panel, there may be a small hole remaining in the fabric covering. Simply scrape the fabric in this area with your fingernail and the hole will completely disappear. TIP When using lighter colored fabrics, make sure your hands are clean!