Auralex Acoustics SonoFlat System SFS-112 Manuals

Installation Guidelines Thank you for Purchasing Auralex ® Total Sound Control ® Products! SonoFlat SFS-112 System Components Congratulations on purchasing a SonoFlat™ SFS-112™ System from Auralex® Acoustics. You’re now on your way to creating a world class listening environment. SonoFlat Systems offer a sophisticated look by utilizing a specialized flat-faced cut of Auralex’s industry-leading Studiofoam. The SFS-112 system contains both SonoFlat Panels and SonoColumns, which when used together, provide incredibly effective broadband absorption in any room. Use the SFS-112 alone for treatment of small to medium-sized rooms or in combination with other Auralex products for full control of larger spaces. Tubetak Pro™ 5 SonoFlat Panels™ 24 SonoColumns™ 4 SonoCollars™ 4 SFS-112 SonoFlat Systems ™ 843-606 | Rev. 1 | 062606 EF Recommended Additional Installation Materials • Caulk-gun (for Tubetak Pro) • Tape measure • Carpenters Level • Small ladder (depending on ceiling height) • Pencil SonoFlat SFS-112 General Information SonoColumn Installation Guide Optional Additional Installation Materials • Foamtak Spray Adhesive* • T-Pins * This system includes Tubetak Pro Adhesive, which is safe to use on all included products. You may wish to use Auralex’s Foamtak Spray Adhesive for quicker drying times. Foamtak is available through all Auralex authorized dealers. ➋ Apply Tubetak Pro to either the back or the beveled edge of the SonoColumn, depending on chosen placement. ➊ Mark intended location of each SonoColumn. SonoColumn Placement Options ➋ ➊ ➍ ➌ Flush in corner At 45° to corner Side-by-side in corner On wall w/ Collars Or SonoFlat Panel Installation Guide ➋ Apply Tubetak Pro to the back of the SonoFlat Panel, as pictured. ➌Carefully press SonoFlat Panel to the marked location of the wall or ceiling. Maintain continuous pressure. Depending on environmental and surface conditions, it will take anywhere from 2-4 minutes to hold. ➊Mark intended location of each SonoFlat Panel on the wall or ceiling. SonoColumn Installation Guide Continued ➍ Place SonoCollar around SonoColumn, if desired. The inside section of each SonoCollar can also be used to increase the height of the SonoColumn by 6”. ➌ Carefully press SonoColumn to the marked location of the wall or ceiling. Maintain continuous pressure. Depending on environmental and surface conditions, it will take anywhere from 2-4 minutes to hold. TIP For a stronger hold, with the adhesive applied, press SonoColumn firmly into place, immediately remove it and press it firmly again into the same spot. Or TIP You can use T-Pins to temporarily hold the panel in place while the adhesive sets.