Avante SMART FLEX 2 Manuals

SMART FLEX 2 ADJUSTABLE BED MANUAL TABLE OF CONTENTS Safety ………...………………………………….….…1 Care ………………………...……………… ………...3 Features...…………..………………..……….…….....4 Unpacking Your Base ………………….….…...........5 Attaching Legs & Retainer Bar to the Base …………6 Hand Control Overview………………….….…........7 Reprogramming Hand Control Positions..………….8 Syncing Long Single Bases ....…………..…….……..9 Troubleshooting ..……………………………..……..10 Product Guarantee ………..…………………....…...12 SAFETY ATTENTION: Important Safety Disclaimers Read all instructions before using your adjustable base. Save these instructions WARNING Always unplug the base from electrical outlet before servicing any part of the base. Unplug the base before cleaning. To safely disconnect, ensure base is in a flat position with all motors off. TO REDUCE THE RISK OF SHOCK, FIRE OR INJURY: For optimal safety and operation, plug the bed base into a surge protector (not included). Ensure to always unplug the base from the electrical outlet before servicing or cleaning any part of the base. Keep the power cord away from heated surfaces. Discontinue use of the bed base and contact a qualified service centre if it has a damaged cord or plug, it is not working properly, or it has been dropped into water. Only use this bed base for its intended use as described in this manual. Do not use accesso- ries/ attachments that are not recommended by the manufacturer. Improper connection of the equipment can result in the risk of electrical shock, electrical fire or fault if the plug does not fit your outlet. Contact a qualified electrician to install a suitable outlet. PETS AND CHILDREN: Dispose of all packing materials immediately after opening as it may pose a risk to small children and pets. To avoid injury, it is not advised to allow children and small pets to play under the bed. Children should not operate the bed base without adult supervision. 1. NOTES: SAFETY · To reduce the risk of falls on height adjustable bases, the base should always be in its lowest position for sleeping and resting. The high position should only be used for carer’s access to the user, ease of entry and exit of bed for the user and ease of making the bed. · A minimum of 2 able and fit adults should be used when lifting or moving the beds. It is recommended to use trolleys or other lifting/moving devices where possible · Careless use of naked flames, cigarettes or other heat sources could set fire to this product · Do not operate whilst any person is under the base whilst raising/lowering or adjusting the bed · Care should be taken that no body parts are in or near the adjustable frame while operating · Ensure the cabling of the bed is free from the mechanism · Don’t run over electrical cables when moving the bed · Do not manipulate or conduct electrical maintenance on the motors or any of the beds electrical components or cables. Any electrical work must be fa- cilitated by a qualified tradesperson WARNING - Stay clear of moving parts while in motion. - Before adjusting, make sure children and pets are clear of moving ..parts and are not under bed base. - Do not allow children to operate bed base without adult supervision 2