Avaya Starset Manuals

Customer Instruction Booklet: StarSet® Headset Maintenance Hint for Optimum Performance Replace the Versatip every 6 months or sooner if it hardens, shrinks, tears, cracks or becomes misshapen. Clean the Versatip daily with a cloth dampened with warm water; do not use cleaning solvents as they may damage the Versatip or cause skin irritation. Adjusting the Voice Tube With one hand, hold the capsule securely against your head. With your other hand, pull out or push in the voice tube and rotate the tip so it is approximately 1/2" away from your face at the corner of your mouth. (Refer to FIGURE 6) Maintenance Hint for Optimum Performance Replace your voice tube every six months. Attaching StarSet® to Glasses StarSet is designed to fit comfortably with glasses. If you desire a more secure fit, use the Eyeglass Clip. Attach the clip to the side on which you wear your headset. A For plastic frames, slip the clip onto the temple of your glasses with the grips for the headset facing away from your head. (Refer to FIGURE 7A) B For metal or wire frames, pull back the tab on top of the clip. Then, slip the clip onto the temple of your glasses with the grips for the headset facing away from your head. The clip should be secure when the tab is released. (Refer to FIGURE 7B) Attach the headset by slipping the voice tube balljoint into the clip. (Refer to FIGURE 7B) Quick Disconnect Your headset model is equipped with a Quick Disconnect module. This feature allows you to temporarily disconnect your headset without removing your headset, thus freeing you to perform a task away from the phone. Your conversation is quickly resumed by reconnecting the Quick Disconnect. Before attempting to use your headset, be sure that the two Quick Disconnect halves are connected. FIGURE 5 FIGURE 6 FIGURE 7 FIGURE 8 1 1 2 A B To temporarily disconnect your headset, grasp the Quick Disconnect as shown and pull straight apart. (Refer to FIGURE 8) To resume your conversation, reconnect the two halves of the Quick Disconnect. Placing and Receiving Calls with the Modular Amplifier For headset use, depress the middle button (labeled “ON/OFF”) so that the color indicator is visible. (Refer to FIGURE 9) To place a call, remove the telephone handset from its cradle. You should hear your dial tone. Dial normally. To end the call, hang up the handset. To receive a call, remove the handset from its cradle. You can now hear and be heard by the calling party. To end the call, hang up the handset. For handset use, depress the “ON/OFF” button again so that the color indicator does not appear. Pick up your handset as you would normally. Setting the Volume Control To set the volume control to the hearing level most comfortable for you, start with the wheel turned to number 3, the lowest level. To increase the volume, rotate the wheel to a higher number. (Refer to FIGURE 10 or 11, as appropriate) Using the Mute Button on the Modular Amplifier To mute your voice while still hearing the caller, depress the “MUTE” button so that the color indicator is visible. (Refer to FIGURE 12) To resume speaking to your caller, depress the “MUTE” button again so that the color indicator does not appear. IF YOU HAVE ANY QUESTIONS, PLEASE CONTACT YOUR AVAYA REPRESENTATIVE AT 800-628-2888 49346-01 (10•00) FIGURE 9 FIGURE 10 FIGURE 11 FIGURE 12 1 2 2 3 1 2 3 4 3 4