Behringer 961 Interface Manuals

Quick Start Guide 961 INTERFACE Legendary Analog Multi-channel Trigger Converter Module for Eurorack Controls (1) AUDIO IN – Use this 3.5 mm jack to route an audio signal into the module for conversion to a V-Trig (voltage trigger) signal. The audio signal passes through the SENSITIVITY control before being converted, and the final, converted signal then exits the module at the V-TRIG OUT parallel connections immediately to the right of the SENSITIVITY knob. (2) SENSITIVITY – Use this knob to adjust the gain of the audio signal coming into the module through the AUDIO IN jack. Rotate the knob until you find a setting that gives you the best audio-to-voltage conversion. (3) V-TRIG OUT – Use the parallel jacks to route the converted audio-to-voltage V-Trig signal back out of the module via cables with 3.5 mm TS connectors. (4) S-TRIG IN – Route S-Trig (switch trigger) control signals into the module via cables with 3.5 mm TS connectors for conversion to V-Trig (voltage trigger) signals. The converted V-Trig signal comes back out of the module via the parallel V-TRIG OUT jacks immediately to the right of the S-TRIG IN jack. (5) V-TRIG OUT – Use these parallel jacks to send the converted V-Trig signal back out of the module via cables with 3.5 mm TS connectors. (6) V-TRIG IN A/B – Use these rows of 3.5 mm jacks to route in multiple V-Trig (voltage trigger) signals for conversion to an S-Trig (switch trigger) signal that exits the module via the S-TRIG OUT jack assigned to this section of the module. The V-TRIG IN A row of inputs go straight to conversion and output, while the V-TRIG IN B row of inputs pass through the SWITCH-ON TIME control before being combined with the converted A signal for final output through the S-TRIG OUT jack. When any valid V-TRIG input activates the S-TRIG output, any other V-TRIG input activity will be ignored until the first V-TRIG cycle has ended. (7) SWITCH-ON TIME – Use this knob to manually limit or extend the “ON” time duration of V-Trig signals coming in through the V-TRIG IN B row of input jacks. The “ON” time can be varied from 40 milliseconds to a full 4 seconds. (8) S-TRIG OUT – This jack routes the final S-Trig signal from the V-TRIG IN A/B jacks back out of the module via cables with 3.5 mm TS connectors. Power Connection The 961 INTERFACE module comes with the required power cable for connecting to a standard Eurorack power supply system. Follow these steps to connect power to the module. It is easier to make these connections before the module has been mounted into a rack case. 1. Turn the power supply or rack case power off and disconnect the power cable. 2. Insert the 16-pin connector on the power cable into the socket on the power supply or rack case. The connector has a tab that will align with the gap in the socket, so it cannot be inserted incorrectly. If the power supply does not have a keyed socket, be sure to orient pin 1 (-12 V) with the red stripe on the cable. 3. Insert the 10-pin connector into the socket on the back of the module. The connector has a tab that will align with the socket for correct orientation. 4. After both ends of the power cable have been securely attached, you may mount the module in a case and turn on the power supply. (1) (2) (4) (5) (7) (6) (8) (3) all-guide s.com

Quick Start Guide 961 INTERFACE Legendary Analog Multi-Channel Trigger Converter Module for Eurorack V 1.0