Black Horce Model Liberty Manuals

SPECIFICATION Made in Vietnam.  Wingspan : 1.440 mm 56.7 in.  Length : 1.090 mm 43 in.  Weight : 1.2 kg 2.64 Lbs. Parts listing required(not included):  Radio : 04 channel.  Servo : 03 servos.  Motor : AXI2808.24.  Battery: 3 CELLS - LI - POLY - 11.1v - 2000 mA.h.  Propeller : 9 x 6  Speed control: 25A. INSTRUCTION MANUAL BOOK. LIBERTY. INSTRUCTION MANUAL 2 This instruction manual is designed to help you build a great flying aeroplane. Please read this manual thoroughly before starting assembly of your LIBERTY. Use the parts listing below to identify all parts. WARNING. Please be aware that this aeroplane is not a toy and if assembled or used incorrectly it is capable of causing injury to people or property. WHEN YOU FLY THIS AEROPLANE YOU ASSUME ALL RISK & RESPONSIBILITY. If you are inexperienced with basic R/C flight we strongly recommend you contact your R/C supplier and join your local R/C Model Flying Club. R/C Model Flying Clubs offer a variety of training procedures designed to help the new pilot on his way to successful R/C flight. They will also be able to advise on any insurance and safety regulations that may apply. TOOLS & SUPPLIES NEEDED.  Thick cyanoacrylate glue.  30 minute epoxy.  5 minute epoxy.  Hand or electric drill.  Assorted drill bits.  Modelling knife.  Straight edge ruler.  2mm ball driver.  Phillips head screwdriver.  220 grit sandpaper.  90° square or builder’s triangle.  Wire cutters.  Masking tape & T-pins.  Thread-lock.  Paper towels. Some more parts. HARDWARE PACK COWLING. Landing gear..... To avoid scratching your new airplane, do not unwrap the pieces until they are needed for assembly. Cover your workbench with an old towel or brown paper, both to protect the air- craft and to protect the table. Keep a couple of jars or bowls handy to hold the small parts af- ter you open the bag. Please trial fit all the parts. Make sure you have the correct parts and that they fit and are aligned properly before gluing! This will assure proper assembly. LIBERTY ARF is hand made from natural materials, every plane is unique and minor adjustments may have to be made. However, you should find the fit superior and assembly simple. The painted and plastic parts used in this kit are fuel proof. However, they are not tolerant of many harsh chemicals including the follow- ing: paint thinner, C/A glue accelerator, C/A glue debonder and acetone. Do not let these chemi- cals come in contact with the colors on the covering and the plastic parts. PARTS LISTING. FUSELAGE ASSEMBLY  (1) Fuselage. WING ASSEMBLY  (1) Right wing half with pre-installed aileron.  (1) Left wing half with pre-installed aileron. Tail section assembly  (1) Vertical stabilizer with pre- installed rudder.  (1) Horizontal stabilizer with pre- installed elevator halves. SUGGESTION. NOTE. LIBERTY. INSTRUCTION MANUAL 3 + This is not a toy + Be sure that no other flyers are using your radio frequency. + Wear safety glasses. + Keep loose clothing and wires away from the propeller. + Do not start the motor if people are near. Do not stand in line with the side of the propel- ler. + Make motor adjustments from behind the propeller only. Do not reach around the spin- ning propeller. C/A glue C/A glue C/A glue SAFETY PRECAUTION. PLASTIC WING TIP INSTALLATION. See pictures below: Cut. (2) plastic wing tip. REPLACEMENT LARGE PARTS A. B. C. D. E. F. G. B. Fuselage. D. Horizon stabilizer. E. Vertical stabilizer. C. Wing panel. A. Cowling. G. Decal sheet . F. Aluminium wing dihedral brace.