BMS Romans Manuals

Romans Moped Assembly Instructions If you have no mechanical experience, please have the unit professionally assembled. Tools needed: #2 Phillips Screwdriver, 14mm Socket, 12mm Socket, 10mm Socket, 14mm Wrench, Crescent Wrench, Hammer, Allen Wrench, Heavy duty Scissors or Utility Knife. Cut straps off with heavy duty scissors or utility knife. Remove top from box Tilt the box to the rear end of the moped and remove Cut ties holding the bag with scissors or utility knife Using a 14 mm socket, remove the bolts holding together the shipping frame Cut the zip tie holding the bag together using the heavy duty scissors or utility knife Remove the front wheel and trunk from the unit. Turn the key to the right to unlock the seat Open the battery box and remove the contents. The box should contain 1 Sulfuric Acid container, 1 Six Hole Funnel, 1 battery hole plug strip. Remove the tape covering the battery holes. Remove Six Hole Funnel from plastic wrap and place into holes on top of the battery Attach Sulfuric Acid container to the tubes in the Six Hole Funnel Let Sulfuric Acid drain completely into battery Remove Six Hole Funnel and cap battery holes with the battery hole plug strip. Insert battery nut and bolt into battery terminal Remove the front screw under the headlight assembly using a Phillips screwdriver Gently remove the front cowling assembly Slide the handlebar column over the steering shaft. Line up the hole for the screw with the hole in the column Insert the bolt and tighten using a 14 mm socket and 14 mm wrench