Bosch Rexroth CS660 Manuals

CS660/CS661 Spreader Controller Operator Manual 2/13 Bosch Rexroth Canada I December 2020 ı Revision 2.0 Table of Contents 1 Operator Interface and Basic Operation 3 2 Additional feature functions 6 2.1 Conveyor Forward and Reverse 6 2.2 Spinner Forward and Reverse 7 2.3 Spinner & Conveyor Forward and Reverse 7 2.4 Dual Spinner 7 2.5 3 Boom Anti-ice 8 2.6 Air Gate 8 2.7 Gate Read back and Automatic Gate 8 2.8 Lane Control 8 2.9 (4 knob) Spreader + 1Boom Anti-ice 9 2.10 (4 knob) Spreader + 3Boom Anti-ice 10 2.11 (4 knob) Spreader + Cross Conveyor 10 2.12 (4 knob) Spreader + 3 Boom Anti-ice + Cross Conveyor 10 3 Selecting Profiles 10 4 Joystick Operation 11 5 Data Retrieval/Clear Trip Summary 12 6 Error Messages 13 Bosch Rexroth Canada Corp. reserves the right to revise this information at any time and for any reason and reserves the right to make changes at any time, without notice or obligation, to any of the information contained in this piece of literature. The information shown in this manual features the latest version of software as of publication; therefore, some features shown will not exist on older versions of software in use by some customers. Please check for updates at: www.boschrexroth.ca/cs 3/13 Bosch Rexroth Canada I December 2020 ı Revision 2.0 1 Operator Interface and Basic Operation Tap to change material Spinner Rate Normal, Pause, Blast, Unload, & Joy Mode [3]Vehicle speed Press&hold 5s to sim spd [1]Status/Totals: Press&hold icon 5s to clear (without key) Press to unload GSS=0 [6]Load WT Press&hold 2s To enter [4]Toolbox LOG key for Log data PGM key for parms Set vol&dim level [2]Settings (PGM key required) GSS>0 [7]Error Messages wipe up/dn to view (OI & RC versions on the last line) Clear messages (PGM key required) Anti-ice rate [8]Gate Position (tap to change) Pre-wet Rate Turn: Pre-wet Press: Momentary Conveyor Reverse Turn: Spinner Press: Pause Spreading Rate Turn: Anti-Icing (If configured) Turn: Conveyor Press: Blast CS-660 Display CS-661 Display + Knob Console Total dist & qty [5]Driver ID 4/13 Bosch Rexroth Canada I December 2020 ı Revision 2.0 [1] Status/Totals– Display real time status and trip summary. Press&hold icon for 5 seconds to clear. Vehicle stopped Vehicle in motion [2] Settings– Switch to program mode ( a PGM key required) [3] Speed– Displays current ground speed. You can simulate ground speed by pressing and holding in the circle for 5 seconds. The following arrows will appear which will allow you to adjust the speed: [4] Toolbox–This button changes depending whether a Program key is inserted into the display or not. When not inserted, the icon is displayed. Pressing this icon will show the following: When a Log or Program key are inserted you will see the icon instead. Please see the Parameter and Log transfer section in this manual for more information. This button also displays the gps/avl status if gps or avl connection is active. [5]Driver ID– This shows the current Driver ID, and allows the selection and naming of Driver IDs. To select one of four Driver IDs, press on the Driver name and a list will drop down. Press and hold for 5 seconds Adjust speed Up/Down Adjust Volume & Brightness