Briggs & Stratton DOV Extended Life Series Manuals

Operating & Maintenance Instructions Èíñòðóêöèè çà ðàáîòà è òåõíè÷åñêî îáñëóæâàíå Upute za koričtenje i odrďavanje Návod k obsluze a údrďbì Kasutus− ja hooldusjuhend Kezelési és karbantartási útmutató Naudojimo ir aptarnavimo instrukcija LietoĠanas un apkopes instrukcija Instrukcja Obs³ugi i Konserwacji Instrucþiuni de utilizare ºi de întreþinere Èíñòðóêöèè ïî ýêñïëóàòàöèè è òåõíè÷åñêîìó îáñëóæèâàíèþ Navodila za uporabo & vzdrďevanje GB BG CZ CR EE LT PL RO SL RU LV H BRIGGSandSTRATTON.com  Copyright Briggs & Stratton Corporation Milwaukee, Wisconsin 53201 U.S.A. Form No. MS-3734-3/07 Printed in U.S.A. Model 100000 DOV Extended Life Series Series 700 Fig. 2 Fig. 3 Fig. 1 4 1 3 2 7 5 6 8 9 10        Fig. 4       GB GB 1 Note: (This note applies only to engines used in the U.S.A.) Maintenance, replacement or repair of the emission control devices and systems may be performed by any nonroad engine repair establishment or individual. However, to obtain no charge repairs under the terms and provisions of the Briggs & Stratton warranty statement, any service or emission control part repair or replacement must be performed by a factory authorized dealer. ENGINE COMPONENTS Fig. 1 1 Oil fill and dipstick 2 Rewind rope handle 3 Fuel fill cap 4 Air cleaner 5 Speed control lever, if equipped 6 Oil drain plug (located at the bottom of engine) 7 Primer bulb 8 Spark plug 9 Muffler 10 Engine Model / Type / Code number Record your engine Model, Type and Code numbers here for future use. Record your date of purchase here for future use. GENERAL INFORMATION In the state of California, the Model 100000 engines covered in this manual are certified by the California Air Resources Board to meet emissions standards for 125 hours. Such certification does not grant the purchaser, owner or operator of this engine any additional warranties with respect to the performance or operational life of this engine. This engine is warranted solely according to the product and emissions warranties stated elsewhere in this manual. Note: For practical operation, the horsepower loading should not exceed 85% of rated horse‐ power. Engine power will decrease 3‐1/2% for each 1,000 feet (300 meters) above sea level and 1% for each 10° F (5.6° C) above 77° F (25° C). It will operate satisfactorily at an angle up to 15°. Refer to the equipment operator manual for safe allowable operating limits on slopes. SAFETY SPECIFICATIONS This manual contains safety information to make you aware of the hazards and risks associated with engines, and how to avoid them. Because Briggs & Stratton does not necessarily know what equipment this engine will power, it is important that you read and understand these instructions and the instructions for the equipment this engine powers. The engine exhaust from this product contains chemicals known to the State of California to cause cancer, birth defects, or other reproductive harm. WARNING WARNING Briggs & Stratton does not approve or authorize the use of these engines on 3‐wheel All Terrain Vehicles (ATVs), motor bikes, fun/recreational go‐karts, aircraft products or vehicles intended for use in competitive events. Use of these engines in such applications could result in property damage, serious injury (including paralysis), or even death. Symbols Associated with this Engine Explosion Toxic Fumes Shock Hot Surface Kickback Fire Moving Parts On Off Read Operator's Manual Stop Fuel Open Choke Safety Alert Oil Full / Closed Choke Slow Fast Hazardous Chemical A signal word (DANGER, WARNING, or CAUTION) is used with the alert symbol to indicate the likelihood and the potential severity of injury. In addition, a hazard symbol may be used to represent the type of hazard. DANGER indicates a hazard which, if not avoided, will result in death or serious injury. WARNING indicates a hazard which, if not avoided, could result in death or serious injury. CAUTION indicates a hazard which, if not avoided, might result in minor or moderate injury. CAUTION, when used without the alert symbol, indicates a situation that could result in damage to the engine. Engines give off carbon monoxide, an odorless, colorless, poison gas. Breathing carbon monoxide can cause nausea, fainting or death. • Start and run engine outdoors. • Do not start or run engine in enclosed area, even if doors or windows are open. WARNING Starting engine creates sparking. Sparking can ignite nearby flammable gases. Explosion and fire could result. • If there is natural or LP gas leakage in area, do not start engine. • Do not use pressurized starting fluids because vapors are flammable. WARNING GB 2 Gasoline and its vapors are extremely flammable and explosive. Fire or explosion can cause severe burns or death. WHEN ADDING FUEL • Turn engine OFF and let engine cool at least 2 minutes before removing gas cap. • Fill fuel tank outdoors or in well‐ventilated area. • Do not overfill fuel tank. • Keep gasoline away from sparks, open flames, pilot lights, heat, and other ignition sources. • Check fuel lines, tank, cap, and fittings frequently for cracks or leaks. Replace if necessary. WHEN STARTING ENGINE • Make sure spark plug, muffler, fuel cap and air cleaner are in place. • Do not crank engine with spark plug removed. • If fuel spills, wait until it evaporates before starting engine. • If engine floods, set choke to OPEN/RUN position, place throttle in FAST and crank until engine starts. WHEN OPERATING EQUIPMENT • Do not choke carburetor to stop engine. WHEN TRANSPORTING EQUIPMENT • Transport with fuel tank EMPTY. WHEN STORING GASOLINE OR EQUIPMENT WITH FUEL IN TANK • Store away from furnaces, stoves, water heaters or other appliances that have pilot light or other ignition source because they can ignite gasoline vapors. WARNING Rapid retraction of starter cord (kickback) will pull hand and arm toward engine faster than you can let go. Broken bones, fractures, bruises or sprains could result. • When starting engine, pull cord slowly until resistance is felt, then pull rapidly. • Direct coupled equipment components such as, but not limited to, blades, impellors, pulleys, sprockets, etc., must be securely attached. WARNING Rotating parts can contact or entangle hands, feet, hair, clothing, or accessories. Traumatic amputation or severe laceration can result. • Operate equipment with guards in place. • Keep hands and feet away from rotating parts. • Tie up long hair and remove jewelry. • Do not wear loose‐fitting clothing, dangling drawstrings or items that could become caught. WARNING Unintentional sparking can result in fire or electric shock. Unintentional start‐up can result in entanglement, traumatic amputation, or laceration. BEFORE PERFORMING ADJUSTMENTS OR REPAIRS • Disconnect spark plug wire and keep it away from spark plug. WHEN TESTING FOR SPARK • Use approved spark plug tester. • Do not check for spark with spark plug removed. WARNING • Allow muffler, engine cylinder and fins to cool before touching. • Remove accumulated combustibles from muffler area and cylinder area. • Install and maintain in working order a spark arrester before using equipment on forest‐covered, grass‐covered, brush‐covered unimproved land. The state of California requires this (Section 4442 of the California Public Resources Code). Other states may have similar laws. Federal laws apply on federal land. WARNING Running engines produce heat. Engine parts, especially muffler, become extremely hot. Severe thermal burns can occur on contact. Combustible debris, such as leaves, grass, brush, etc. can catch fire. OIL RECOMMENDATIONS CAUTION: Engine shipped from Briggs & Stratton without oil. Before starting engine, fill with oil. Do not over‐fill. • Use a high quality motor oil. • Do not use special additives. Do not mix oil with gasoline. • Choose a viscosity according to average temperature such as SAE 30 weight oil, see chart below. °C ‐30 °F ‐20 0 20 40 60 80 100 ‐20 ‐10 0 10 20 30 40 * ** 32 CAUTION: * Air cooled engines run hotter than automotive engines. The use of non‐synthetic multi‐viscosity oils (5W‐30, 10W‐30, etc.) in temperatures above 40° F (4° C) will result in higher than normal oil consumption. When using a multi‐viscosity oil, check oil level more frequently. ** 30 weight oil, if used below 40° F (4° C), will result in hard starting and possible engine bore damage due to inadequate lubrication. OIL CAPACITY • Engine holds approximately 0.61 liter (20 oz). Fig. 2 OIL PROCEDURE • Check oil level before every use and after every eight (8) hours of continual use. 1. Place engine level and clean around oil fill . 2. Remove dipstick, wipe with clean cloth , insert and tighten down again . Remove dipstick and check oil level. Oil should be at FULL mark . If oil is required, add slowly . Recheck oil level on dipstick . 3. Do not over fill. Overfilling with oil may cause smoking, hard starting, spark plug fouling, and oil saturation of air filter. Drain out excess, if oil level is over FULL mark on dipstick. 4. Tighten dipstick firmly before starting engine. FUEL RECOMMENDATIONS Use clean, fresh, lead‐free gasoline with a minimum of 85 octane. Leaded gasoline may be used if it is commercially available and if unleaded is unavailable. In U.S.A. leaded gasoline may not be used. Some fuels, called oxygenated or reformulated gasolines, are gasolines blended with alcohols or ethers. Excessive amounts of these blends can damage the fuel system or cause performance problems. If any undesirable operating symptoms occur, use gasoline with a lower percentage of alcohol or ether. This engine is certified to operate on gasoline. Exhaust Emission Control System: EM (Engine Modifications). Do not use gasoline which contains Methanol. Do not mix oil with gasoline. Before refueling, allow engine to cool 2 minutes. WARNING Fig. 3 ADDING FUEL Clean around fuel fill  before removing cap. Fill tank to approximately 1 inch below top of neck  to allow for fuel expansion. Be careful not to overfill.