Canarm XB Manuals

M0112_NOV 2020 Page 1 of 8 www.CANARM.COM Canarm Ltd. - Corporate Head Office 2157 Parkedale Avenue, PO Box 367 Brockville, Ontario Canada K6V 5V6 Tel: (613) 342-5424 Fax: (613) 342-8437 [email protected] www.canarm.com WALL EXHAUST FANS BELT & DIRECT DRIVE INSTALLATION AND MAINTENANCE INSTRUCTIONS READ AND SAVE THESE INSTRUCTIONS Models: XB, HV, HVA, HVAR, ADD, ADDR, DDS, DDP, SXB, SADD THE PURPOSE OF THIS MANUAL IS TO AID IN THE PROPER INSTALLATION AND OPERATION OF THE FANS. THESE INSTRUCTIONS ARE INTENDED TO SUPPLEMENT GOOD GENERAL PRACTICES AND ARE NOT INTENDED TO COVER DETAILED INSTRUCTION PROCEDURES. IT IS THE RESPONSIBILITY OF THE PURCHASER TO ASSURE THAT THE INSTALLATION AND MAINTENANCE OF THIS EQUIPMENT IS HANDLED BY QUALIFIED PERSONNEL. Inspect all shipments carefully for damage. THE RECEIVER MUST NOTE ANY DAMAGE ON THE CARRIER’S BILL OF LADING AND FILE A CLAIM IMMEDIATELY WITH THE FREIGHT COMPANY. ELECTRICAL CONNECTIONS WARNING: BE SURE POWER IS OFF AT THE ELECTRICAL PANEL BEFORE WIRING. WARNING: ALL ELECTRICAL WORK SHOULD BE PERFORMED BY A QUALIFIED ELECTRICIAN. INSTALLATION 1. Cut and frame the appropriate wall opening. Fans mounted to a wall require a different wall opening than fans mounted in cabinets or sleeves. For specific dimensions, refer to the submittal drawing for the specific fan configuration. 2. Mount the fan in the opening with the fan panel directly over the load bearing support and if this is not practical angle supports must be provided to transfer the fan weight to the load bearing structure. 3. Caution: The fan contains rotating parts and requires electrical service. Appropriate safety precautions should be taken during installation, operation and maintenance. 4. Warning: Do not install or operate this fan in an environment where combustible materials, gasses or fumes are present unless it was specifically designed and manufactured for that application. 5. A damper, if used, should be securely mounted in a manner that allows free and unobstructed operation. 6. All electrical work must be done, in accordance with all applicable electrical codes, by a qualified electrician. Please follow all applicable national, state/provincial and local codes, all of them will supersede this manual. 7. Prior to wiring ensure the power supply is locked in the OFF position and that the motor nameplate voltage and the supply voltage match. 8. Be sure to keep all wiring clear of any rotating parts. 9. Before starting the fan ensure that the wheel rotates freely.