Clarke Strong-Arm CTJ2CBB Manuals

OPERATION & MAINTENANCE INSTRUCTIONS ORIGINAL INSTRUCTIONS GC 1118- ISS1 HYDRAULIC TROLLEY JACK MODEL NO: CTJ2CBB & CTJ2BMCB PART NO: 7623211 & 7623213 2 INTRODUCTION Thank you for purchasing this CLARKE Trolley Jack. This manual cover s the CTJ2CBB and the CTJ2BMCB which is supplied in a blow moulded case. Before attempting to use this product, please read this manual thoroughly and follow the instructions carefully. In doing so you will ensure the safety of yourself and that of others around you, and you can look forward to your purchase giving you long and satisfactory service. SPECIFICATION Length (exc handle): 440 mm Width: 195 mm Min height of lifting cup: 130 mm Maximum lifting height from floor: 330 mm Weight: 8.75 kg Pump Oil Capacity: 78 ml Rated Capacity: 2 Tonnes GUARANTEE This product is guaranteed against faulty manufacture for a period of 12 months from the date of purchase. Please keep your receipt which will be required as proof of purchase. This guarantee is invalid if the product is found to have been abused or tampered with in any way, or not used for the purpose for which it was intended. Faulty goods should be returned to their place of purchase, no product can be returned to us without prior permission. This guarantee does not effect your statutory rights. 3 SAFETY PRECAUTIONS 1. This jack is for lifting only. Do not move a load using the jack as a dolly. 2. Do not use to lift people. 3. Always inspect the jack before use. Make sure that all parts are in good condition and operating smoothly, and that no cracks or distortion is apparent. If in doubt do not use. Have the damaged parts replaced or consult your CLARKE dealer. 4. Make sure that the jack is on a firm level base, and there is no possibility of it slipping when under load. 5. Make sure the load is taken by the full saddle and that the point of lift on the load, is strong enough to support the load adequately. 6. Do not work under the raised vehicle until it is supported by suitable means e.g. axle stands, NEVER rely on the jack to support the vehicle by itself. 7. Never push a load off the jack. 8. Ensure that all personnel are well clear of a load being raised or lowered. 9. Do not try to lift more then the rated load for the jack. 10. Do not use the jack if an oil leak is apparent. Consult your Clarke dealer. 11. Consult the vehicle handbook to determine the correct lifting points. 12. Always watch the jack and the load during operation. 13. Check the condition of the labels regularly and replace as required. 14. The jack must be maintained and repaired in accordance with the these instructions by suitably qualified persons. 15. Do not make any modifications to this jack or adjust any valves. ENVIRONMENTAL PROTECTION One of the most damaging sources of environmental pollution is oil products. Never throw away used hydraulic oil with domestic refuse or flush it down a sink or drain. Collect any hydraulic oil in a leak proof container and take it to your local waste disposal site. If disposing of this product or any damaged components, do not dispose of with general waste. This product contains valuable raw materials and should be taken to your local civic amenity site for recycling of metal products. WARNING: THE OPERATOR MUST FOLLOW ALL INSTRUCTIONS WITHIN THIS INSTRUCTION BOOKLET