CLIVET G3K0GB-1 Manuals

� C. Art. M03K40M6� ��������� ���������������������������� ����������������������������� ����������������� IT CAN BE COUPLED WITH REMOTE CONDENSER CLIVET SERIES CEM ������ ������������������������������� ������������������������������������������������� ������������������������������������������������ ������� �������������� �������������� ������������������ ��������� THIS MANUAL CONTAINS THE FOLLOWING SECTIONS WHICH ARE TO BE CONSIDERED AN INTEGRAL PART OF THE WHOLE AND ARE THEREFORE NOT TO BE DETACHED G3K0GB-1 R3K0GB-1 E3K0GB-1 F3K0GB-1 C3K0GB-1 General Reception/Positioning Electrical connections Start-up Controls T3K0GB-1 M3K0GB-1 L3K0GB-1 P3K0GB-1 K3K0GB-1 Troubleshooting Routine maintenance Water connections Refrigerant pipes Residual risks ��������� The contents of this manual are designed to assure the correct installation, adjustment and maintenance of the unit; therefore: − read the instructions with due care and attention; − the appliance must be installed, tested and serviced by properly qualified personnel (law n.45, 5.3.1990) licensed in accordance with established legislation. • The manufacturer declines all liability, and guarantee coverage is automatically waived, if electrical and/or mechanical modifications are made to the unit. Tampering and unauthorised repairs or modifications to the unit will automatically void the guarantee. • Observe the safety regulations in force at the time of installation. • Make sure that the characteristics of the mains network conform to the data on the serial number plate inside the electrical panel. • Conserve this manual and the circuit diagram with care. Make sure that they are available for consultation by the operator whenever necessary. • Packing materials (plastic wrappings, expanded polystyrene, nails, etc.) are potentially hazardous and must be kept out of reach of children. Recycle packing materials in accordance with local bylaws. • The water chiller must be used only for the purpose for which it is designed. The manufacturer bears no responsibility in the case of applications other than the specified use. • Disconnect the unit in the case of breakdowns or malfunctions. • If repairs are necessary use only Clivet-approved service centres and always insist on original spare parts. The use of non-original parts and/or unauthorised service centres may result in unsafe operation of the unit. The manufacturer declines all liability for direct or indirect damage to property or injury to persons resulting from failure to adhere to the instructions in this manual. ����������������������������� This unit has been especially designed and manufactured so to prevent any risk to persons and health hazard. For this reason, design solutions fit to eliminate (where possible) any cause of risk and sensibly reduce the probability of danger have been adopted. Please refer to the �������������� section of this manual and strictly observe the behaviour prescriptions listed there in order to prevent any possible risk that hasn’t been possible to avoid in the design stage. Библиотека СОК 