Coats APX Series Manuals

1601 J. P. Hennessy Drive, LaVergne, TN USA 37086 615/641-7533 800/688-6359 Manual Part No.: 85000267 03 HENNESSY INDUSTRIES INC. Manufacturer of AMMCO®, COATS® and BADA® Automotive Service Equipment and Tools. Revision: 02/13 APX Tire Changer Series Unloading Procedures ® User Instructions READ these instructions before placing unit in service KEEP these and other materials delivered with the unit in a binder near the machine for ease of reference by supervisors and operators. This is a supplement to your operating manual and covers unloading pro- cedures for the COATS® APX Series Tire Changers. If you do not have your original operating manual, please call COATS at 1-800-688-6359 to request an additional copy. CAUTION Watch for this symbol: It Means: Hazards or unsafe practices, which may result in minor personal injury or product or property damage. Unload Instructions Review the following unload procedures carefully. Refer to them as necessary when the machine is deliv- ered and unloaded to verify that you are proceeding properly and safely. This unit weighs over 1,200 lbs. Do not attempt to lift or move without assistance. Make sure all moving parts are secured before moving the unit. Proper unit installation is necessary for safe use and efficient operation. Proper installa- tion also helps protect the unit from dam- age and makes service easier. Always place safety poster and instructions near the unit. Machine Delivery Unload Procedure A. It is acceptable to use a fork-truck to unload the machine that is on a pallet from a delivery truck. B. It is acceptable to use a utility tilt trailer to unload the machine that is on a pallet from a delivery truck. C. It is not acceptable and can be dangerous to use a lift-gate delivery truck to unload the machine from a delivery truck. CAUTION CAUTION CAUTION 2 • COATS Unloading Instructions COATS Unloading Instructions • 3 APX80 Unload Instruction 1. Remove lag bolts holding chassis to pallet. 2. Jack up rear of machine; install axle and wheels as shown. 3. Remove ramp planks and position as shown. 4. Jack up front of machine and install axle and wheels as shown. 5. Slowly push machine forward to position offload bracket over jack. 6. Jack up front of machine and slowly move machine off pallet. 7. Locate machine in shop at proper location and remove wheels and temporary off-load bracket. 2 3 4 Offload Bracket 5 6 "X" Offload Bracket Remove Axles, Wheels & Offload Bracket After Locating In Final Position DO NOT Fork Machine Here: Transmission Damages May Occur Secure ramp planks in position with screw as shown. APX80 85000267 03 02/13 4 of 4 © COPYRIGHT 2006 HENNESSY INDUSTRIES AND COATS ALL RIGHTS RESERVED PRINTED IN U.S.A. APX90 Unload Instruction 1. Remove lag bolts holding chassis to pallet. 2. Jack up rear of machine; install axle and wheels as shown. 3. Remove ramp planks and position as shown. 4. Move jack to front (add air pressure to machine). 5. Slowly push machine off pallet. 6. Locate machine in shop at proper location and remove wheels. 2 5 4 Secure ramp planks in position with screw as shown. 3 DO NOT Fork Machine Here: Transmission Damages May Occur APX90