CO/Tech 50053 Manuals

GREAT BRITAIN • CUSTOMER SERVICE tel. 020 8247 9300 e-mail [email protected] internet www.clasohlson.co.uk Ver. 20151125 Wireless Magnetic Contact Switch Art.no 36-6048 Model 50053 Please read the entire instruction manual before using the product and then save it for future reference. We reserve the right for any errors in text or images and any necessary changes made to technical data. In the event of technical problems or other queries, please contact our Customer Services. Installation Note: The magnetic switch is primarily intended for controlling lights but can also be used for other purposes. This instruction manual describes the use of the magnetic switch when connected in a light circuit. 1. Activate the battery by pulling the plastic tab out of the battery holder. 2. Check that the timer setting on the back of the magnetic switch is set to zero (0). 3. Place the magnetic switch and the receiver within 1 m of each other. 4. Place the surface of the magnet and the magnetic switch together. 8. Set the activation time of the paired receiver by turning the setting knob on the back of the magnetic switch. - 0: If, for example a door is opened, the connected light is switched on immediately. When the door is closed, the connected light is switched off immediately. No delay. - 2 m: If, for example a door is opened, the light is switched on and stays on for 2 minutes regardless of whether the door remains open or is closed again. - 4 m: If, for example a door is opened, the light is switched on and stays on for 4 minutes regardless of whether the door remains open or is closed again. Changing the battery Pull the battery holder straight down out of the magnetic switch. Observe the markings on the battery holder to ensure the correct polarity. The positive terminal of the battery (+) should be upwards, facing you. 9. Attach the magnetic switch to the frame of the door or window in question. Use an appropriate fastening method for the surface in question. 10. Attach the magnet to the door leaf or the window sash no further than 10 mm from the magnetic switch. Note: The magnetic switch and the magnet must be in line with each other. Use the line and the arrows on the units as a guide. Unpairing the magnetic switch from the receiver 1. Set your receiver to learning mode (refer to the instruction manual of your receiver). 2. Hold in the button on the magnetic switch until the LED indicator on the front of the magnetic switch goes out. The magnetic switch is now no longer paired with the receiver. Troubleshooting guide The wireless magnetic switch is not working. • Is the magnetic switch paired with the receiver as described above? Try pairing them again. • Check the battery in the magnetic switch. • Is the magnetic switch too far away from the receiver (25 m)? • Check that the light is properly connected to the receiver and that it is switched on and not faulty. • Try plugging the light into another electrical outlet to make sure that it works. Responsible disposal This symbol indicates that this product should not be disposed of with general household waste. This applies throughout the entire EU. In order to prevent any harm to the environment or health hazards caused by incorrect waste disposal, the product must be handed in for recycling so that the material can be disposed of in a responsible manner. When recycling your product, take it to your local collection facility or contact the place of purchase. They will ensure that the product is disposed of in an environmentally sound manner. Specifications Frequency 433.92 MHz Max range 25 m Activation time 0–20 min Battery 1 × CR2032 5. Set your receiver to learning mode (refer to the instruction manual of your receiver). 6. Separate the magnet and the magnetic switch (more than 10 mm). 7. The devices will now be paired together.