Craftsman 358.798980 Manuals

___ Operator's Manual CRRFTSMRN_ 1.9 cu. in./32cc 2-Cycle GASOLINE BLOWER/VACUUM Model No. 358.798980 / / H WARNING: Read and follow all Safety Rules and Operating Instructions before first use of this product. For answers to your questions about this product: Call 7 am-7 pro, Mon-Sat; Sun, 10 am-7 pm 1-800-235-5878 Sears. Roebuck and Co., Hoffman Estates, IL 60179 USA 530-084301 03/16/96 Limited Warranty Statement 2 Storage 9 Safety Rules 2 Troubleshooting Chart t0 Assembly 4 Parts List 11 Operation 5 Maintenance 7 Spanish 14 Service & Adjustments 8 Parts and Ordering Back FULL TWO YEAR WARRANTY ON SEARS BEST CRAFTSMAN" GAS BLOWER For two (2) years from date of purchase, when this Gas Blower is maintained, lubricated, and tuned up according to the instructions in the operator's manual, Sears witl repair, free of charge, any defects in material or workmanship. This warranty excludes blower tubes, spark plug, and air cleaner, which are ex- pendable parts and become worn during normal use. If this blower is used for commercial purposes, thiswarranty applies for 90 days from the date of purchase. Ifthis Blower is used for rental purposes, this warranty applies for 30 days from the dale of purchase. This warranty applies only while this product is in use in the United States. WARRANTY SERVICE 1SAVAILABLE BY RETURNING THE BLOWER TO THE NEAREST SEARS SERVICE CENTER IN THE UNITED STATES. This warranty gives you specific legal rights, and you may also have other rights which vary from slate to state. Sears, Roebuck and Co. Dept. D/81TWA Hoffman Estates, IL 60179 Failure to follow all Safety Rules and Pre- cautions can result in serious injury. KNOW YOUR UNIT • Read your Operator's Manual care- fully until you completely understand and can follow all wamings and safety rules before operating the unit. • Restrict unit to users who understand and wil! follow all warnings and safety rules in this manual. PLAN AHEAD • Always wear eye protection when op- erating, servicing, or performing maintenance on unit. Wearing eye protection will help to prevent rocks or debris from being blown or rico- cheting into eyes and face which can result in blindness and/or serious in- jury. • Always wear respirator or face mask when working with unit in dusty envi- ronments. o Secure hair above shoulder length. Secure or remove jewelry, loose clothing, or clothing with loosely hanging straps, ties; tassels, etc. They can be caught in moving pads. • Do nol operate the unit when you are tired, ill, upset, or if you are under the influence of alcohol, drugs, or me_- cation. • Keep children, bystanders, and ani- mals away from work area a mini- mum of 50 feet (15 m) when starting or operating unit. • Inspect the area before starting the unit. Remove all debris and hard ob- jects such as rocks, glass, wire, etc. that can ricochet, be thrown, or other- wise cause injury or damage during operation. HANDLE FUEL WITH CAUTION - Eliminate al! sources of sparks or flame (including smoking, open flames, or work that can cause sparks) in the areas where fuel is mixed, poured, or stored, . Mix and pour fuel in an outdoor area: store fuel in a cool, dry, well venti- lated place; use an approved, -2- marked container for all fuel pur- poses. • Do not smoke while handling fuel or while operating the unit. , Do not fill fuel lank while engine is running. ,, Wipe up luel spills before starting en- gine. • Move at least 10 feet (3 meters) away from fuel and fueling site before starling engine. OPERATE YOUR UNIT SAFELY • Stop the engine before opening the vacuum inlel door. The engine must be stopped and the impeller blades no longer lurning Io avoid serious in- jury Irom the rotating blades. • Inspect unit before each use for worn, loose, missing, or damaged parts. Do not use until unit is in proper working order. • Keep outside surfaces free of oil and fuel. • Never slart or run engine inside a closed room or building. Breathing exhaust fumes can kill. • To avoid static electricity shock, do not wear rubber gloves or any other insulated gloves while operating unit. • Do not set unit on any surface except a clean, hard area while engine is running. Debds such as gravel, sand, dust, grass, etc. could be picked up by the air intake and thrown out through discharge opening, damag- ing unit, property, or causing serious injury to bystanders or operator. • Avoid dangerous environmenls. Do not use in unventilated areas or where explosive vapors or carbon monoxide build up could be present. • Do not overreach or use from unsta- ble surfaces such as ladders, trees, steep slopes, rooftops, etc. Keep firm footing and balance at all times. • Never place ob.iects inside the blower tubes; always direct the blowing de- bris away from people, animals, glass, and solid objects such as trees, automobiles, walls, etc. The force of a_rcan cause rocks, dirt, or sticks to be thrown or to ricochet which can hurt people or animals, break glass, or cause other damage. • Never run unit without the proper equipment attached. When using your und as a blower, always install blower tubes. When using your unit as a vacuum, always install vacuum tubes and vacuum bag assembly. Make sure vacuum bag assembly is completely zipped. • Check air intake opening, blower tubes, vacuum tubes, and elbow tube frequently, always with engine stopped and spark plug discon- nected. Keep vents and discharge tubes free of debris which can accu- mulate and restrict proper air flow. • Never place any object in the air in- take opening as this could restdct proper air flow and cause damage to the unit. • Never use for spreading chemicals, fertilizers, or other substances which may contain toxic materials. • To avoid spreading fire, do not use near leaf or brush fires, fireplaces, barbecue pits, ashtrays, etc. • Use only for jobs explained in this manual. MAINTAIN YOUR UNIT PROPERLY • Have all maintenance other than the recommended procedures described in the Operator's Manual pedormed by Sears Service. • Disconnect spark plug before per- forming maintenance except for car- buretor adjustments. ° Use only recommended CRAFTS- MAN® replacement parts; use of any other parts may void your warranty and cause damage to your unit. • Empty fuel tank before storing the unit. Use up fuel left in carburetor by starting engine and letting it run until it stops. • Do not use any accessory or attach- ment other than those recommended by manufacturer for use with your unit. • Do not store the unit or fuel in a closed area where fuel vapors can reach sparks or an open flame from hol water heaters, electric motors or switches, furnaces, etc. ,, Store in a dry area out of reach of children. SPECIAL NOTICE: For users on U.S. Forest Land and in some states, in- cluding California(Public Resources Codes 4442 and 4443), Idaho, Maine, Minnesota, New Jersey, Oregon, and Washington: Certain internal combus- tion engines operated on forest, brush, and/or grass covered land in the above areasarerequired to be equipped with a spark arrestor, maintained in effective working order, or the engine must be constructed, equipped, and maintained for the prevention of fire. Check with your state or local authorities for regu- lations pertaining to these require- ments. Failure to follow these require- ments is a violation of the law. This unit is not factory equipped with a spark ar- restor; however, a spark arrestor is available as an optional part. If a spark arrestor is required in your area, con- tact Sears Service for the correct kit. The spark arrestor, blower tubes, and nozzles must be assembled to unff to be in full compliance with regulations. SPECIAL NOTICE: Exposure to vibra- tions through prolonged use of gaso- line powered hand tools could cause blood vessel or nerve damage in the fingers, hands, and joints of people prone to circulation disorders or abnor- mal swelling. Prolonged use in cold weather has been linked to blood ves- sel damage in otherwise healthy people. If symptoms occur such as numbness, pain, loss of Strength, change in skin color or texture, or loss of feeling in the fingers, hands, or joints, discontinue the use of this too! and seek medical attention. An ant!vibration system does not guaran- tee Ihe avoidance of these problems. Users who operate power tools on a COntinualand regular basis must moni- tor closely their physical condition and the condition of this tool_ CARTON CONTENTS Check carton contents against the fol- lowing list. Model 358.798980 • Blower • Blower tube • Nozzle • Upper vacuum tube • Lower vacuum tube • Elbow tube o Vacuum bag ° 2-Cycle Engine Oil NOTE: It is normal for the fuel filter to rattle in the empty fuel lank. ASSEMBLY WARNING: If received assembled, repeat a!l steps to ensure your unil is properly assembled and all fasteners are secure. • No tools are required for assembly. BLOWER TUBE ASSEMBLY • Assemble the blower tube and nozzle to the unit (turn clockwise to tighten). Blower Slower _ Tube. Outlet _ B_ __Nozzle VACUUM BAG ASSEMBLY • Open the zipper on the vacuum bag and insert the etbow tube. • Push the end of the elbow tube with the grooves through the small bag tube opening. Make sure the bag tube opening is flush against the raised rib in the middle of the tube. • Close the zipper on the bag. Make sure the zipper is closed completely and the zipper seam is tucked toward inside of the bag. Raised Si___ Bag Tube Efbow_ JI _ Opening Tube _ - _ Looped Zipper I _ _ Strap 0°% VACUUM TUBE ASSEMBLY WARNING Slop engine and be sure the impairer blades have stopped turn- ing before opening the vacuum inlet door or attempting to insert or remove the vacuum tubes. The rotating blades can cause sedous injury. ,, Remove blower tube from engine. = Insert a screwdriver into the latch area on the vacuum inlet cover. _r_l _ sl_er _ (_ ._ Vacuum LA_'-J/7,-4, InletCover