Cree LR4E Series Manuals

15˚ Shield Angle LR4E-15 LR4E-15C 30˚ Shield Angle LR4E-30 LR4E-30C INSTALLATION INSTRUCTIONS LR4E Light Engine Including: LR4E-15, LR4E-15C, LR4E-30, LR4E-30C •� LR4-Engines (all versions) are designed for both Insulated (completely buried in insulation) and Non-insulated appli- cations. •� Designed for use with a 120 volt, 60 hertz protected circuit (fuse box, circuit breakers) and 90° C rated supply wire. •� LR4E is for use with a H4 recessed pan assembly and must be used within an enclosed recessed can. See installation instructions for H4 for more information. IMPORTANT SAFETY INFORMATION Read all instructions before installation 1. WARNING - Risk of Electric Shock. Disconnect power at fuse or circuit breaker before installing or servicing. 2. Check to make sure that all recessed can connections have been prop- erly made and the fixture is grounded to avoid potential electrical shocks. 3. Do not handle energized fixture with wet hands, when standing on wet or damp surfaces, or in water. STEP 1: Remove taped GU-24 socket from side wall of recessed can and pull down to attach to the top of the LR4E. Align pins and socket and turn clockwise until locked. See Figure 1. STEP 2: Remove the LR4E from the packaging and rotate the “Flip Clips” clockwise until the pointed tip of the clip lines up with the arrow on the metal base. Loosen one of the screws inside the H4 can. Unwind the green ground wire and hook it over the screw. Re-tighten screw to secure ground hook. See Figure 2. STEP 3: Push the LR4E with the flip clips in the ready position up into recessed can until the bottom flange of the LR4E is flush with the ceiling. The LR4E should be firmly gripping the can. To remove the LR4E rotate counter-clockwise until clips release and you can pull the unit down. See Figure 3. A A A INSTALLING THE LR4E 1 2 3 Flip Clip Flip Clip Flip Clip