Crestron CLWI-KPLEX Manuals

CLWI-KPLEX In-Wall Wireless Lighting Keypad, 230 Vac Installation Guide Description The Crestron® CLWI-KPLEX is a companion keypad for CLWI- line of dimmers and switches. It provides lighting and audio control from multiple locations around the home or office. It is designed to recall scenes, dim loads up and down, and adjust the volume using the customizable button layout. The CLWI-KPLEX is shipped with a six-button configuration preinstalled on the keypad. The button configuration can be replaced with the included large rocker switch or any combination of up to two adjacent half-size rocker buttons or triple-button pads. All buttons are configurable for up to three discrete functions via single-press, double-press, and press-and-hold functionality. The specifications for the CLWI-KPLEX are listed below. SPECIFICATION DETAILS Power Requirements 220-240 Vac, 50/60 Hz, line power Environmental Temperature Humidity 0° to 40 °C (32° to 104 °F) 10% to 90% RH (non-condensing) Enclosure Mountable in a 1-gang UK (BS 4662) electrical box or 1-gang European (DIN 49073) electrical box that is 35 mm (1.38 in) or deeper; Requires a FP-INTENSE or FP-PURE style faceplate (both not included) Dimensions Height Width Depth 72 mm (2.80 in) 72 mm (2.80 in) 32 mm (1.24 in) including front face with buttons Weight 80 g (3 oz) The dimensions of the CLWI-KPLEX are shown below. 72 mm (2.80 in) 72 mm (2.80 in) 32 mm (1.24 in) 51 mm (2.00 in) 51 mm (2.00 in) 21 mm (0.82 in) Additional Resources Visit the product page on the Crestron website (www.crestron.com) for additional information and the latest firmware updates. Use a QR reader application on your mobile device to scan the QR image. Installation To install the CLWI-KPLEX, do the following. CAUTION: Use on 10 A branch circuits only. CAUTION: Use 1 x 1.5 - 2.5 mm² wire that complies with BS6004:2000/IEC 60245 and local electrical codes. NOTE: Use only copper wire rated for at least 75° C. 1. Turn the power off at the circuit breaker. 2. Wire the device as shown in the following diagram. Use 1 x 1.5-2.5 mm² (14-12 AWG) wire. Secure the connections to the CLWI-KPLEX by inserting the wires into the back of the unit and tightening the screws on the top of the unit with a small flat-head screwdriver. Neutral Earth Live Line 230 Vac Tighten the screws with a small flat-head screwdriver. 3. Push all power wires back into the electrical box and fasten the device to the electrical box with the provided screws. NOTE: Use care when placing the device in the electrical box. Pinched wires may cause a short circuit. 4. Attach the faceplate (not supplied). 5. Ensure that all buttons, including the program button, actuate without sticking. 6. Restore power at the circuit breaker. Multigang Installation In multigang installations, several devices are grouped horizontally or vertically in one electrical box. When ganging vertically the devices snap together by sliding the bottom of the upper device into the top of the lower device. This allows the devices to be mounted closer together. For a smooth appearance, one-piece multigang faceplates (not included) can be installed. NOTE: When devices are ganged in a horizontal position, the devices do not interlock. NOTE: When installing into a multigang box, do not fully tighten devices to box until the faceplate has been aligned.