Crown Boiler AWI037 Manuals

1 Tel: (215) 535-8900 • Fax: (215) 535-9736 • www.crownboiler.com Manufacturer of Hydronic Heatings Products P.O. Box 14818 3633 I. Street Philadelphia, PA 19134 AWI & TWI Series Gas-Fired Natural Draft Hot Water Boilers INSTALLATION INSTRUCTIONS These instructions must be affixed on or adjacent to the boiler WARNING: Improper installa- tion, adjustment, alteration, service or maintenance can cause property damage, injury, or loss of life. For assistance or additional information, consult a qualified installer, service agency or the gas supplier. Read these instructions carefully before installing. Models: • AWI037 • AWI061 • AWI095 • AWI128 • AWI162 • AWI195 • AWI229 • AWI262 • AWI295 • TWI061 • TWI095 • TWI128 • TWI162 CROWN Boiler Co CROWN Boiler Co 2 INSIDE FRONT COVER (LEAVE BLANK) 3 Table of Contents I. Product Description .................................................. 1 II. Specifications ............................................................ 1 III. Before Installing ......................................................... 4 IV. Locating the Boiler ...................................................... 4 V. Air for Combustion & Ventilation .............................. 5 VI. Venting ....................................................................... 8 VII. Gas Piping ................................................................ 11 I Product Description The AWI series boiler is a cast iron gas fired water boiler designed for use in closed forced circulation heating systems. This boiler is a Category I draft diverter equipped appliance, which must be vented by natural draft using a lined masonry or listed metal chimney system. An adequate supply of air for combustion, ventilation and dilution of flue gases must be available in the boiler room. The TWI series boiler is identical to corresponding sized AWI boiler except for the addition of baffles in the flue passages to obtain higher AFUEs. The TWI is not available with a standing pilot or for use with propane gas. VIII. System Piping ............................................. 12 IX. Wiring ......................................................... 16 X. Start-Up & Checkout .................................. 21 XI. Service & Maintenance............................... 27 XII. Troubleshooting ......................................... 29 XIII. Parts ............................................................ 34 II Specifications 1 FIGURE 1A: STANDARD CONFIGURATION (SEE PAGE 3 FOR LETTER DIMENSIONS)