CSUN 305-72M Manuals

IEC Installation Guide Web： Q/CSUN.J30.0002 To be a leading company of the renewable category of the world Contents 1、 、 、 、General Information 2、 、 、 、Safety Precaution ⑴Storage and unpacking ⑵Installation Announcements 3、 、 、 、 4、 、 、 、 ⑴ ⑵ ⑶ ⑷ ⑸ 5、 、 、 、 6、 、 、 、 1、 、 、 、General Information This guide contains information regarding the installation and safe handling of the photovoltaic module (hereafter is referred to as “module”) produced by China Sunergy (Nanjing) Co., Ltd (hereafter is referred to as “CSUN”.) Installers must read and understand the guide before installation. Any questions, please contact our customer service department for further explanations. The installer should conform to all safety precautions in the guide and local codes when installing a module. Failure to follow these instructions may result in death, bodily injury or damage to property. Before installing a solar photovoltaic system, installers should become familiar with the mechanical and 2、 、 、 、 ⑴ ⑴ ⑴ ⑴ ◆ ◆ ◆ ◆ ◆ ◆ ◆ ⑵ ⑵ ⑵ ⑵ ◆ When installing the system, abide with all local, regional and national statutory regulations. Obtain a building permit where necessary. ◆ Installing solar photovoltaic systems may require specialized skills and knowledge. Installation should be performed only by qualified persons. Installers should assume the risk of all injury that might occur during installation, including, without limitation, the risk of electric shock. ◆ Abide with the safety regulations for all other components used in the system, including wiring and cables, connectors, charging regulators, inverters, storage batteries and rechargeable batteries, etc. Use only equipment, connectors, wiring and support frames suitable for a solar electric system. Always use the same type of module within a particular photovoltaic system. ◆ Photovoltaic modules are designed for outdoor use. Modules may be mounted on ground, rooftops, vehicles or boats. Proper design of support structures is responsibility of the system designers and installers. Use of mounting holes is suggested in a following paragraph. ◆ Do not install or handle the modules when they are wet or during periods of high wind. Keep the junction box cover closed at all times. ◆ Do not use or install broken modules. If the glass is broken, or the back sheet is torn, contact with any modules surface or the frame can cause electric shock. ◆ ◆ ◆ ◆ current. ◆ ◆ ◆ Under normal outdoor conditions the module will produce current and voltages that are different than those listed in the date sheet. Data sheet values are values expected at standard test conditions. Accordingly, during system design, values of short-circuit current and open-circuit voltage should be multiplied by a factor of 1.25 when determining component voltage ratings, conductor ampacity, fuse ratings and size of controls connected to the modules or system output. 3、 、 、 、Product Identification Each module has five labels providing the following information: