Curt Group Aries TrailCrusher 2156002 Manuals

ARIESAUTOMOTIVE.COM • NEED ASSISTANCE? • 877.287.8634 • 2156002-INS-RA • PAGE 1 INSTALLATION MANUAL 2156002 Parts List 1 TrailCrusher™ bumper 8 Flat washer, M12 8 Lock washer, M12 8 Hex nut, M12 8 Backup washer Tools Required Ratchet Philips screwdriver Socket set Flathead screwdriver Allen wrench Level Level of Difficulty Moderate Notes and Maintenance Before you begin installation, read all instructions thoroughly. Proper tools will improve the quality of installation and reduce the time required. To protect the product, wax after installing. Regular waxing is recommended to add a protective layer over the finish. Do not use any type of polish or wax that may contain abrasives that could damage the finish. For polished, gloss and other smooth finishes, polish may be used to clear small scratches and scuffs on the finish. Mild automotive detergent may be used to clean the product. Do not use dish detergent, abrasive cleaners, abrasive pads, wire brushes or other similar products that may damage the finish. Refer to the table to the left when securing hardware during the installation process to help prevent damage to the product or vehicle. Product Photo Product Registration CURT Group stands behind our products with industry leading warranties. You can help us continue to improve our product line and help us understand your needs by registering your purchase by visiting: warranty.curtgroup.com/surveys At CURT Group, customer is king. We value your feedback and we use that information to make improvements on our products. Please, take a minute and let us know how we are doing. Torque Specifications M12 bolt 70 ft-lbs. Use above torque setting unless otherwise noted ARIESAUTOMOTIVE.COM • NEED ASSISTANCE? • 877.287.8634 • 2156002-INS-RA • PAGE 2 Step 1 Remove the front fascia by removing the eight plastic push fasteners from the upper edge of the lower front fascia. Using a socket, remove the two 5mm screws securing the lower edge of the plastic fascia. Step 4 Once all of the bolts have been removed, carefully lift the factory bumper from the frame and set it on a flat work surface. Step 2 From behind the factory bumper on the passenger side, disconnect the fog light wiring harness. Step 3 Remove the four nuts on the driver side securing the factory bumper in place. Repeat this step on the passenger side. ARIESAUTOMOTIVE.COM • NEED ASSISTANCE? • 877.287.8634 • 2156002-INS-RA • PAGE 3 Step 5 On the driver side, remove the plastic cover over the factory fog light. Remove the fog light and plastic housing from the factory bumper. Disconnect the wiring harness from the fog light. Remove the factory fog light from the plastic housing. Repeat this step on the passenger side. ARIESAUTOMOTIVE.COM • NEED ASSISTANCE? • 877.287.8634 • 2156002-INS-RA • PAGE 4 Step 6 Begin removing the fog light wiring harness from the factory bumper by removing the retainer clips from the eight bumper mounting studs. Remove the four bolts securing the beam to the bumper. Lift the beam from the bumper to expose the fog light harness. Remove the plastic push fasteners securing the wiring harness to the bumper. The harness will be used with the new bumper. Step 7 Install the factory fog lights into the new bumper. Be sure to fully engage the plastic push fasteners on the factory fog light into the mounting holes of the bumper.