CyberData SIP Paging Server Manuals

931023B Connecting a CyberData SIP Paging Server to a Bogen PCM2000 Zone Paging System The IP Endpoint Company

+ - + - The IP Endpoint Company 930996B Pyle Home PCM30A Amplifier to SIP Paging Server Connections Pyle Home PCM30A Amplifier Notes 1. Power off the amplifier and reduce the volume by turning the Paging Output Level counter- clockwise before connecting the CyberData device and powering the amp back on. 2. Ensure that the amplifier is powered off prior to connecting the CyberData device and turn the dial for Paging Level Output fully counter-clockwise. 3. Connect the CyberData device, and then power the amplifier back on. 4. Slowly raise the Paging Level Output (clockwise) to adjust the volume during testing. 2 conductor, shielded speaker wire is recommended. SIP Paging Server Connections Keep as short as possible Shield/Drain Wire Shield/Drain Wire Hi Lo Hi Lo Balanced GENERAL ALERT Caution Equipment Hazard: All equipment should be powered down prior to making wiring connections and changing switch positions. s Page Port Connections Pin Description 1 Fault Sense Input (Common). 2 Fault Sense Input (Sense). 3 Positive 600-Ohm Audio Outputa a.The 600-Ohm audio output of the page port is also suited for interfaces with lower input impedances. 4 Negative 600-Ohm Audio Outputa 5 Audio Ground Reference. 6 Relay Contact - Commonb b.1 Amp at 30 VDC for continuous loads. 7 Relay Contact - Normally Openb