CyberPower RMCARD202 Manuals

QUICK INSTALLATION GUIDE Remote Management Card RMCARD202 Intelligent Remote Management Card allows a UPS system to be managed, monitored, and configured K09-0000064-02 INSTALLATION GUIDE 5. Connect the Ethernet cable to the LAN port of the CyberPower Remote Management Card. 6. Turn on the UPS. 4. Re-install and tighten the retaining screws. 3. Install the CyberPower Remote Management Card into the expansion port. 2. Remove the two retaining screws of the expansion port cover then remove the cover. 1. Turn off the UPS before removing the expansion port cover on the UPS. Definitions for LED Indicators Step 2. Configure the IP address for the CyberPower Remote Management Card. Method 1: Using the Power Device Network Utility Tool 1. Install the Power Device Network Utility Tool from the included CD. It is located on the CD in the \tools\nework folder. Double click the “Power Device Network Utility” installation file, “Setup.msi” to begin the installation. 2. After installation is completed, run the “Power Device Network Utility” program. (Under “All Programs”, select “CyberPower Power Device Network Utility”). 3. The main dialog of the Power Device Network Utility Tool program is shown in Figure 1. The tool will display all Remote Management Cards present on the network. The "Refresh" button is used to search the entire local network again. 4. Select the Remote Management Card you are setting up. Click on the Tools menu and select “Device Setup” or double click the Remote Management Card you want to configure. 5. You can modify the IP Address, Subnet Mask, and Gateway address for the Device MAC Address listed in the Device Network Settings window, as shown in figure 2. The default IP Address is 192.168.20.177 and the default Subnet Mask is 255.255.255.0. 6. Modify the IP, subnet mask or gateway address. Enter the new addresses into the corresponding fields. Link LED color Off On(Yellow) TX/RX LED color Off On(Green) Flash Condition The Remote Management Card is not connected to the Network or the Remote Management Card power is off The Remote Management Card is connected to the Network The Remote Management Card power is OFF The Remote Management Card power is ON - Receiving/transmitting data packet - Reset finished RMCARD202 RX/TX Link Ethernet connector LINK Indicator RX/TX Indicator Figure 1. The main window of the “Power Device Network Utility” program. Figure 2. The Device Network setting window. Step 1. Hardware Installation

User’s Manual Remote Management Card RMCARD202/RMCARD203 RMCARD302/RMCARD303 Intelligent Remote Management Card allows a UPS system/environment sensor to be managed, monitored, and configured Version 1.6

User’s Manual Network Management Card RMCARD202 Intelligent Network Management Card allows a UPS system to be managed, monitored, and configured Version 1.0 E-K01-SNMP005-0