D-Link DAP-1950 Manuals

INSTALLATION • DAP-1950 || AC1900 High-Performance Mesh Wi-Fi Range Extender • Quick Installation Guide • Quick Installation Card ENGLISH PACKAGE CONTENTS OPTION 1 D-LINK WI-FI APP SETUP QUICK WPS SETUP OPTION 2 Quick Installation Guide DAP-1950 AC1900 High-Performance Mesh Wi-Fi Range Extender Download the D-Link Wi-Fi app and launch it. 1 / Tap Install New Device. Scan the QR code on the Quick Installation Card. Follow the on-screen instructions to complete the setup. 2 / D-Link Wi-Fi D-Link Wi-Fi Plug your Range Extender into an available outlet near your wireless router and wait until the Status LED is blinking amber (this may take up to 3 minutes). You can move it to a more suitable location after it is set up. If the status LED does not light up, ensure the power toggle switch underneath is in the “on” position. 1 / Press the WPS (Wi-Fi Protected Setup) button on your wireless router for 3 seconds. An LED should start blinking on your router. If it does not blink, see the important note below. 2 / Once confirmed that the WPS light is blinking on your router, within one minute, press the WPS button on your Range Extender for 2-3 seconds. The Status LED should start to blink green. 3 / When the Status LED turns solid green (may take up to 3 minutes), this indicates that your Range Extender is securely connected to your wireless router. 4 / Your setup is complete! You can now unplug and move your Range Extender to a location between your Wireless Router and the area where you want wireless coverage. By default, your Range Extender will share the same Wi-Fi name and password as your Router. If after moving your Range Extender, the signal strength indicator is showing one single amber bar or if your Range Extender LED does not turn solid green within 3 minutes, move your Range Extender to a wall outlet closer to your wireless router. IMPORTANT WPS may be disabled on some Routers or Modems. If the WPS Status LED on your Router or Modem does not start blinking when you have pressed the WPS button, try again and hold it a little longer. If it still does not blink, STOP, and configure your Range Extender using Option 1: D-Link Wi-Fi App Setup. WPS Button Model Name: DEVICE Wi-Fi Name: dlink-XXXX Password: XXXXXXXX S/N: 123456789 SETUP QR CODE