Danfoss VLT MCB 106 Manuals

The instructions provide information about installing the VLT® 24 V DC Supply MCB 106 on VLT® Midi Drive FC 280. VLT® 24 V DC Supply MCB 106 is a low voltage supply to the control card. The intended use case is to keep the fieldbus communication of the control card active at all time during a mains power loss or power cycle. It does not enable full operation of the LCP (including the parameter settings) without connection to mains. The specifications of VLT® 24 V DC Supply MCB 106 are described in Table 1.1. Input voltage 24 V DC +15% (Maximum 37 V in 10 s) Reversed voltage input protection Yes Output voltage 19.9 +0.6 V Output power Minimum 10 W Input capacitance load <110 uF Power up delay <0.6 s Table 1.1 VLT® 24 V DC Supply MCB 106 Specifications 1 VLT® 24 V DC Supply MCB 106 2 Cable 3 Plug Illustration 1.1 VLT® 24 V DC Supply MCB 106 Overview NOTICE VLT® 24 V DC Supply MCB 106 only supports CANopen®, PROFIBUS, PROFINET, and EtherNet/IP™ variant of VLT® Midi Drive FC 280. CANopen® is a registered trademark for CAN IN AUTOMATION international users and manufacturers group e. V. EtherNet/IP™ is a trademark of ODVA, Inc. Only Danfoss authorized, qualified personnel is allowed to use this equipment. The personnel must be familiar with the instructions and safety measures described in the VLT® Midi Drive FC 280 Operating Guide. Installation Instructions VLT® 24 V DC Supply MCB 106 VLT® Midi Drive FC 280 Danfoss A/S © 02/2019 All rights reserved. MI07G202