Dedicated Micros Oracle Manuals

Oracle Dome Camera Installation Manual www.dedicatedmicros.com Dedicated Micros ©2008 2 Oracle Whilst every attempt is made to ensure these manuals are accurate and current, Dedicated Micros reserve the right to alter or modify the specification of the machine described herein without prejudice. Contents Introduction........................................................3 Components supplied - External........................5 Components supplied - Internal.........................6 Electrical Connections - External.......................7 Electrical Connections - Internal........................9 Mounting Configurations - External....................10 Mounting Configurations - Internal.....................13 Control Configuration - All Models.....................17 Upgrading Dome Software.................................22 Dome Configuration...........................................24 Troubleshooting.................................................25 Notes..................................................................26 Dedicated Micros ©2008 3 Oracle Introduction Congratulations on choosing a Dedicated Micros Oracle dome camera. This manual will provide all the necessary information to install the Dedicated Micros Oracle Dome Camera. RF Interference warning This is a class A product. In a domestic environment this product may cause radio frequency interference, in which case the user may be required to take adequate measures. Product Safety WARNING • Installation and servicing is only to be carried out by suitably qualified and experienced personnel and should conform to all local codes. • Only power low voltage cameras from the provided power supply. Use only a Class 2 power supply with a maximum current of 1.5 amps and the wiring as specified in the National Electrical Code ANSI/NFPA 70. This camera range is designed for use in general purpose CCTV applications and has no other purpose. Only operate your camera between the temperatures of -10°C and +40°C. This low voltage camera must be powered with either a 12V DC or a 24V AC power supply. Do not operate your camera outside its specified power supply range. FCC CLASS B REGULATORY NOTICE This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a different circuit different to the receiver. Consult the dealer or an experienced radio/TV technician for help. Modifications not expressly approved by the manufacturer could void the user’s authority to operate the equipment under FCC rules. Dedicated Micros ©2008 4 Oracle Camera Care In order to avoid damaging your camera, note the following points: CAUTION • Remove all packaging inserts and the protective film from the dome cover before using the camera. • This installation should be made by a qualified service person and should conform to all local codes. CE NOTICE (EUROPEAN UNION). Marking by the symbol CE indicates compliance of this DM product to the Electromagnetic Compatibility Directive 89/336/EEC, and the Low Voltage Directive 73/23/EEC of the European Union. Such marking is indicative that this system meets the following technical standards. • EN 61000-6-3 EMC Standard Residential, Commercial and Light Industry. • EN 61000-3-3 Limitations of voltage changes, fluctuations and flicker in public low- voltage supply systems for equipment with rated current up to 16A. • EN 61000-3-2 Limits for harmonic current emissions for equipment with rated current up to 16A. • EN 50130-4 Immunity requirements for components of fire, intruder and social alarm systems. • EN 60950 Safety of IT and related equipment. • EN 55022 Class B. Radiated Emissions Standard, suitable for Commercial or Residential use. • EN 60825-1 Safety standard for LED’s and Lasers. Further details about these applicable standards can be obtained from Dedicated Micros Ltd. 1200 Daresbury Park, Daresbury, Cheshire, WA44HS. A “Declaration of Conformity” with all relevant European Union Directives has been made, is on file and is available from the Dedicated Micros address above. This product is marked with the CE symbol and indicates compliance with all applicable directives. Directive 89/336/EEC. A “Declaration of Conformity” is held at Dedicated Micros Ltd., 1200 Daresbury Park, Daresbury, Cheshire, WA44HS.