Dialogic DM/F300-1E1-PCIU Manuals

Dialogic DM3 Fax Boards DM/F300-1E1-PCIU Quick Install Card Part Number 64-0069-02 Copyright © 2001-2007 Dialogic Corporation. All Rights Reserved. Before You Begin Protecting the Board from Damage CAUTION: All computer boards are sensitive to electrostatic discharge (“ESD”). Handle all static- sensitive boards and components at a static-safe work area, and observe anti-static precautions at all times. If you are not familiar with ESD safety precautions, visit http://www.dialogic.com/support/hwinstall to learn more. Unpacking the Board Unpack the Dialogic® DM/F300-1E1-PCIU Fax Board (“board”) according to the following steps: 1. Prepare a static-safeguarded work area. 2. Carefully remove the board from the shipping carton and anti-static packaging. Handle the board by the edges and avoid touching the board’s components. 3. Lay the board on the static-dissipative work surface. Note: Place boards in static-shielding bags when carrying boards from station to station. CAUTION: Do not remove the board from the anti-static packaging until you are ready to install it. Observe proper anti-static precautions at all times. Configuring the Hardware Board Identification The device driver, part of the system software, assigns board instance numbers in ascending order (beginning with 0) as it detects each board in your system. A board instance number is the identification (ID) number used by the system software to recognize the board. Note: If you add or remove a board, the system may change the existing board instance numbers. Windows Systems Leave SW1 set to the factory default of 0 to let the system automatically assign board instance numbers by PCI bus slot number. After the hardware and the system software are installed, refer to the Dialogic® Configuration Manager (DCM) utility to retrieve the assigned board instance ID number(s). For more information about board identification, see the DCM online help. Linux Systems In a Linux system, you must set SW1 to a unique number for each installed board. Use a non-magnetic screwdriver to turn SW1 to one of 16 board ID settings, 0–9 or A–F. After the hardware and the system software are installed refer to the proper configuration files to retrieve the assigned board instance ID number(s). For more information about Linux configuration files, see the Dialogic ® System Software documentation. Installing the Hardware 1. With your computer on the static-safe work area, switch off the power and disconnect all power cords from the electrical outlets. 2. Remove the computer cover. 3. Select an empty PCI expansion bus slot and remove the slot’s retaining screw and access cover plate (if applicable). 4. If you are not installing your board in an ISA form factor PCI slot, remove the ISA edge retainer from the board. Physical Description 1 5 10 9 8 2 3 4 6 7 JP2B JP2A Red Yellow Green Loopback CH4 CH3 CH2CH1 1. RJ-48C Jack: Connector to external digital telephone network interface. 2. General Network Interface Alarm LED 3. Power LED 4. Reset LED 5. SW1: Rotary switch to set board identification (Linux systems only). 6. Alarm LEDs: During power-up, indicate Power- On Self-Test (POST) status. During operation CH1 LEDs indicate network alarms for the telephone trunk. Red—Indicates loss of signal. Yellow—Indicates loss of frame synchronization at far end of external network. Green—Indicates signal present; powered up and receiving signal from external sources. Loopback—Indicates loopback mode is activated. 7. CT Bus/MVIP Bus Termination Jumpers: Bus signal is terminated when the corresponding jumper clip is installed. Note: Signal must be terminated only on boards at each end of the CT Bus cable. JP2A: CT Bus termination jumper JP2B: MVIP Bus termination jumper 8. P3: CT Bus connector 9. ISA Edge Retainer 10. Signal Processing Daughterboard