Digital Watchdog SiteWatch DW-DTWT Manuals

Quick Start Guide Attention: This document is intended to serve as a quick reference for initial setup. It is recommended that the user read the entire instruction manual for complete and proper installation and usage. Tel: +1 (866) 446-3595 / (813) 888-9555 Technical Support Hours: 9:00AM – 8:00PM EST, Monday thru Friday digital-watchdog.com NOTE: Download all your support materials and tools in one place. 1. Go to: http://www.digital-watchdog.com/resources. 2. Search your product by entering the part number in the ‘Search by Product’ search bar. Results for applicable part numbers will populate automatically based on the part number you enter. 3. Click ‘Search’. All supported materials, including manuals and quick start guide (QSGs) will appear in the results. INSTALLATION AND USER GUIDE The Walk-Tester is an installation tool that helps to setup DW’s motion detectors on-site. *Each detector has been fitted with and infra-red LED emitter. When activation occurs, the transmitter sends a signal. This signal is then received by the Walk-Tester and a very bright LED flashes and an alarm sounds is also activated. Under normal situations both the LED and the sounder can be seen and heard up to 164ft (50m). *To verify that your detector is compatible with the Walk-Tester, remove the cover and look at the bottom of the circuit board for a blue IR LED (see figure 1 below). If the blue LED is present, the Walk-Tester will be able to communicate with the detector. Fig.1 Detector’s IR emitter Fig. 2 Walk-Tester holder and bracket DW-DTWT | Walk-Tester for motion detectors WHAT’S IN THE BOX 1x Walk-Tester 1x mount bracket 1x holder 1x quick setup guide