DKS 6400 - UL 325 Class 1 Manuals

6400 6400 6400 Copyright 2009 DoorKing, Inc. All rights reserved. TM Copyright 2012 DoorKing, Inc. All rights reserved. UL 325 Compliant CLASS CERTIFIED TO CAN/CSA C22.2 NO. 247 CONFORMS TO ANSI/UL-325 VEHICULAR GATE OPERATOR HP 53382 MODEL SERIAL VOLTS PHASE AMPS 60 Hz MAX GATE LOAD DoorKing, Inc., Inglewood, CA Gate Operator and Control Box Mounting Vehicular Swing Gate Operator To wire this operator and complete the installation, refer to a specific control box “Wiring/Owner’s manual”. CLASS CERTIFIED TO CAN/CSA C22.2 NO. 247 CONFORMS TO ANSI/UL-325 VEHICULAR GATE OPERATOR HP 53382 MODEL SERIAL VOLTS PHASE AMPS 60 Hz MAX GATE LOAD DoorKing, Inc., Inglewood, CA 6400-065-T-8-12 6400-065-T-8-12 1 6400 SPECIFICATIONS 17” 12” 6” 2 5/8” 2” 2 1/4” 9 3/8” 8 1/2” 19” 15 3/4” 8 1/2” 1 1/2” Dia. Plastic Drainage Pipe (Not Supplied) Pivot Point Linking Arm Pivot Point Manual Release Handles Manual Release Key Drive Arm Gate Arm Locking Bracket Locking Bracket Gate Arm Limit Plate Drive Arm Release Handle Linking Arm DoorKing, Inc. reserves the right to make changes in the products described in this manual without notice and without obligation of DoorKing, Inc. to notify any persons of any such revisions or changes. Additionally, DoorKing, Inc. makes no representations or warranties with respect to this manual. This manual is copyrighted, all rights reserved. No portion of this manual may be copied, reproduced, translated, or reduced to any electronic medium without prior written consent from DoorKing, Inc. Class of Operation Model 6400 - UL 325 Class I Type of Gate Vehicular Swing Gates Only Gate Operator Voltage 24 VDC Current 3 Amps Motor Torque 300 Nm Max Gate Weight 300 Lbs. Max Gate Length 8 Feet Cycles Per Hour 20 Per Hour with AC connected (Cycles will vary with battery power ONLY) Speed 90° in approximately 18 seconds Control Box Types • 115 VAC 60 Hz Single Phase Input Power - 24 VDC Output Power to Gate Operators • 24 Volt Solar Input Power - 24 VDC Output Power to Gate Operators 6400-065-T-8-12 2 TABLE OF CONTENTS SPECIFICATIONS 1 6400 Specifications ASTM F2200 Standard for Gate Construction Important Safety Instructions Instructions regarding intended installation: Important Notices UL 325 Entrapment Protection Glossary Swing Gate Requirements Swing Gate Protection 1 3 3 3 4 5 6 7 8 INSTALLATION 9 9 10-11 12 13-14 15 15 16 17 18 Manual Key Release Installation of 6400 Drive Motor Orientation and Components Installation Mounting Control Box with Conduit Install Warning Signs In-Ground Loops Photo Sensor Positions Accessory Items 6400 Primary/Secondary 4302 Circuit Board Connection