DMP Electronics 862N Manuals

2841 E. Industrial Drive Springfield, MO 65802-6310 800-641-4282 862N Network Interface Card and 862P Printer Interface Card Description The 862N card allows the 1912XR Command Processor™ Panel to communicate alarm and system reports to the central station over existing data networks. The 862N provides selectable baud rate settings and Transmit and Receive LEDs for verifying network communication. The 862P card allows you to connect a serial printer to the 1912XR and provide local activity reports of system events. The 862P is suitable for use with the SCS-PTR printer from DMP or a compatible 40 or 80 character serial printer. Expansion Modules The 862 card also provides a 4-wire LX-Bus™ allowing you to connect additional zone and output expander modules or single point expanders to the 1912XR panel. Installing the 862 module 1. Remove AC and battery power from the 1912XR panel before installing the 862 card. 2. Remove the paper strip from the base of the plastic standoff. 3. Carefully align the 40 pin connector of the 862 with the J9 connector on the 1912XR panel. 4. Gently press the 862 onto the J9 connector while applying even pressure to both sides. Installing the data cable The data cable supplied with the 862 card contains one 8-pin modular end and one DB-25 male end. 1. Plug the cable's 8-pin modular end into the J1 Data Cable Connector on the 862. 2. Plug the cable's DB-25 male end into the appropriate connector on your data network equipment for the 862N or serial printer for the 862P. Refer to the documentation supplied with your data network equipment for additional system connections. Applying power to the 1912XR panel After installing the 862 card and data cable, you can restore power to the 1912XR panel. Installing expander modules The LX-Bus™ on the 862 card allows you to add up to 100 zones of protection to the 1912XR using the Models 711, 711E, 714, and 715 Zone Expanders. You can also add up to 100 Model 6155LX or DS775LX PIRs or 5845LX Glassbreak Sensors to the LX-Bus™. For output expansion, you can add multiple 716 Output Expanders (4 Form C outputs and 4 annunciator outputs) and 717 Graphic Annunciator Modules (20 annunciator outputs). Power for these devices is provided on the LX-Bus™ through the Black and Red wires of the expansion harness. To complete the installation: 1. Connect the Black wire (J13) from the 862 card to terminal 10 on the 1912XR panel. 2. Connect the Red wire (J14) from the 862 card to terminal 7 on the 1912XR panel. LT-0202 (10/98) Figure 1: Installing the 862 on the 1912XR panel INSTALLATION 1912XR Interface Cards 1912XR Panel Bk - Aux. Common Gr - Serial Data Out Yl - Serial Data In Rd - Aux. Positive The 862 card plugs onto the J9 Expansion Connector on the 1912XR Black Red - To terminal 7 Black - To terminal 10 Adhesive backed standoff attaches to microprocessor. Red Receive and Transmit Jumpers J6 and J7 { Loop Expander Harness for connecting loop and output expander modules to the 862 card. J1 Data Cable Connector. J3 Loop Expansion Connector. Baud Rate Jumpers J11 and J12 FORCE CTS Jumper J15