Doro Primo 401 Manuals

Power on the phone Press and hold the red button on the phone to turn it on and off. If the SIM card is valid but protected with a PIN code (Personal Identification Number), Enter PIN is displayed. Enter the SIM PIN code and press OK ( upper left corner of keypad). Delete with Delete ( upper right corner of keypad). Setting the language The default language of the phone menu, messages and so on is determined by the SIM card used (Automatic). You can always switch between the languages supported by the phone. 1. Press Menu â Settings â OK. 2. Select Phone settings â OK. 3. Select Language â OK. 4. Select language â OK. Setting time and date 1. Press Menu â Settings â OK. 2. Select Phone settings â OK. 3. Select Time and date â OK. 4. Select Set time/date â OK. 5. Enter the time (HH:MM) â . 6. Enter the date (DD/MM/YYYY) â OK. 1. Receiver/ loudspeaker Make phone calls holding the cell phone to the ear 2. Display 3. Left soft key Right soft key Selection of the main menu Open the phone directory 4. Call button Dial and answer calls; open the call log 5. Arrow keys In idle state to open the quick access list to open messages. Scroll up and down in menus and lists 6. Speed dial Speed dial the numbers saved under M1, M2 and M3 with one keystroke 7. * key In idle state: to enter: “*”/ “+” / “P”/“W“; Input: special characters 8. # key In idle state: long keystroke to toggle between ring tone on/off; Input: toggle input modes 9. Microphone 10. Numerical keys In idle state: input of phone number; long keystroke on 1: calling the voice mail box (the phone number must be stored) 11. Exit key Exiting a call, returning to idle state; switching the phone on/off 12. LEDs Notification of missed calls and received text mes- sages, Battery charging 13. Micro USB port For battery charger 14. Headset connector For standard headset with 3.5 mm phone jack Installing the SIM card and the battery The SIM card holder is located inside the battery compartment. CAUTION Only use batteries, charger and accessories that have been approved for use with this particular model. Connecting other accessories may be dangerous and may invalidate the phone’s type approval and guarantee. 1. Remove the cover of the battery compartment by placing a thumb on the cover’s riffle on the rear of the phone casing and pushing the cover downwards. If the rechargeable battery is inserted, remove it by lifting it on the notch at the top using a finger nail. 2. Insert the SIM card by carefully pushing it under the metal bracket on the lower side. Make sure the contacts of the SIM card point downwards and the cut-off corner fits exactly in the recessed shaping of the holder. The contacts of the SIM card must not be scratched or bent. Try not to touch the contacts with your fingers. 3. Insert the rechargea- ble battery by pushing it into the battery compartment ensuring that the three contacts on the front touch the three spring contacts on the bottom in the battery compartment. 4. Replace the cover and push it upward using gentle pressure with the thumb until it snaps securely into place again. When the battery performance is low, the empty battery symbol flashes to indicate the battery state and an alarm signal will sound. To recharge the battery, connect the mains adapter to the micro USB connector on the bottom side of the phone. When the battery charger is connected to the phone, the red charging LED is on. The battery charge status moves when the battery is charging (visible in the upper right corner of the display). A complete charging process of the recharge- able battery takes approximately 3 hours. When the battery is fully charged the animation of the battery charging status stops. 1 2 3 4 5 6 7 8 9 10 11 14 12 13 Primo™ 401 Quick Start Guide English © IVS GmbH 2015 • All rights reserved QSG_Primo_401_en_A4(A7)_v1.1 English Version 1.1 0197 Specifications Network: GSM 900/1800 MHz Dimensions: 91 mm x 46 mm x 19 mm Weight: 74 g Battery: 3.7V/800 mAh Li-ion battery Operating ambient temperature: Min: 0°C (32°F) Max: 40°C (104°F) Charging ambient temperature: Min: 0°C (32°F) Max: 40°C (104°F) Storage temperature: Min: -20°C (-4°F) Max: 60°C (140°F) Changes and errors excepted. EN