DualLite LSN Manuals

Installation Instructions and User Manual For Inverter Power Systems 1.0 - 17.5 KVA 2 READ AND FOLLOW ALL SAFETY INSTRUCTIONS IMPORTANT SAFEGUARDS When using electrical equipment, you should always follow basic safety precautions, including the following: 1. Read and follow all safety instructions. 2. Do not install the LSN (Life Safety Network) inverter system outdoors. 3. Do not install near gas or electric heaters or in other high-temperature locations. 4. Use caution when servicing batteries. Battery acid can cause burns to skin and eyes. If acid is spilled on skin or in the eyes, flush with fresh water and contact a physician immediately. 5. Equipment should be mounted in locations where it will not be readily subjected to tampering by unauthorized personnel. 6. The use of accessory equipment not recommended by the manufacturer may cause an unsafe condition and may void the warranty. 7. Do not use this equipment for other than intended use. 8. All servicing of this equipment must be performed by qualified service personnel. SAVE THESE INSTRUCTIONS IMPORTANT SAFETY INSTRUCTIONS The installation and use of this product must comply with all national, federal, state, municipal, or local codes that apply. Please read this manual thoroughly before operating the LSN Inverter System. For technical assistance, contact Dual-Lite’s Systems Technical Support Center at 1-800-848-6439. Technicians are available during normal working hours (EST). 3 Table of Contents Section 100 System Installation Instructions Description Page 101. Unit Specifications............................................................................................................................................................ 4 102. Receiving, Moving and Storing Systems and Batteries................................................................................................ 5 102.1 Shipping Damage................................................................................................................................................................ 5 102.2 Moving Units and Batteries.................................................................................................................................................. 5 102.3 Temporary Storage of Units and Batteries........................................................................................................................... 5 103. Installation Requirements................................................................................................................................................. 6 103.1 Operating Environment........................................................................................................................................................ 6 103.2 High Altitude Operation........................................................................................................................................................ 6 104. Cabinet Mounting (Physical)............................................................................................................................................ 7 104.1 Dimensions.......................................................................................................................................................................... 7 104.2 Standard Cabinet Configurations......................................................................................................................................... 7 104.3 Cabinet Installation........................................................................................................................................................... 8,9 105. Battery Installation and Connection.............................................................................................................................. 10 105.1 Tools....................................................................................................................................................................................11 105.2 Installation Considerations................................................................................................................................................. 12 105.3 Battery Installation Procedure....................................................................................................................................... 12-16 105.4 DC Fuse Installation........................................................................................................................................................... 17 105.5 Electronics Cabinet Voltage Check.................................................................................................................................... 17 106. AC Connections............................................................................................................................................................... 18 106.1 AC Wiring Preparations...................................................................................................................................................... 18 106.2 AC Input and AC Output Connections................................................................................................................................ 19 107. RS-232 Communications Connections......................................................................................................................... 20 108. Final Installation Checklist............................................................................................................................................. 20 109. Maintenance Bypass Switch Phase Check................................................................................................................... 21 110. System Start-Up Procedure............................................................................................................................................ 22 111. System Verification......................................................................................................................................................... 22 Section 200 User Manual Description ............................................................................................................................................................................Page 201. User Interface Panel........................................................................................................................................................ 23 201.1 User interface Panel Basics............................................................................................................................................... 23 201.2 Using The Interface Panel.................................................................................................................................................. 24 201.3 How To Display A Parameter.............................................................................................................................................. 24 201.4 How to Clear A User Password.......................................................................................................................................... 24 201.5 How o Change A Parameter Value..................................................................................................................................... 24 201.6 How to Change Operating Modes...................................................................................................................................... 25 201.7 Parameter "Hot Key" Listing By Function...................................................................................................................... 26,27 202. System Diagnostics........................................................................................................................................................ 28 203. System Auto Testing....................................................................................................................................................... 28 203.1 Weekly Test........................................................................................................................................................................ 28 203.2 Monthly Test....................................................................................................................................................................... 28 203.3 Annual Test......................................................................................................................................................................... 28 203.4 Extended Power Outages.................................................................................................................................................. 28 203.5 Performing A Manual Test.................................................................................................................................................. 29 204. Stored Test Results (Logs)............................................................................................................................................. 29 205. Alarms.............................................................................................................................................................................. 31 206. Communications............................................................................................................................................................. 33 207. Unit Communication Options......................................................................................................................................... 33 208. Service Options............................................................................................................................................................... 34 Section 300 Maintenance, Warranty and Technical Support 300. Maintenance..................................................................................................................................................................... 35 300.1 Safe Shut Down Procedure............................................................................................................................................... 35 300.2 Routine System Maintenance............................................................................................................................................ 36 300.3 Changing Air Filters............................................................................................................................................................ 36 300.4 Battery Maintenance and Replacement........................................................................................................................ 37-39 301. Warranty Information...................................................................................................................................................... 39 302. Technical Service and Support...................................................................................................................................... 39 Appendix 1....................................................................................................................................................................... 40