Edelbrock 5721 Manuals

©2007 Edelbrock Corporation Brochure #63-5721 Catalog #5721 Rev. 12/07 - AJ/mc Page 1 of 1 ® EDELBROCK CAT-BACK EXHAUST SYSTEM For 2007-2008 Toyota FJ Cruiser 2WD & 4WD Catalog #5721 INSTALLATION INSTRUCTIONS Please study these instructions carefully before installing your new Edelbrock Cat-Back Exhaust System. If you have any questions, please contact our Technical Hotline at: 1-800-416-8628 , 7am - 5pm, Monday-Friday, Pacific Standard Time or e-mail us at [email protected]. Suggested Tools for Installation: ❑3/8" ratchet and metric sockets ❑14mm, 15mm, and 17mm Wrenches ❑Jack and jackstands ❑Liquid penetrant and rubber lubricant DISASSEMBLY 1. Raise and support vehicle. 2. Remove factory exhaust system from the flange located behind the catalytic converter. ASSEMBLY 1. Disconnect the fuel vapor return line from the vapor canister located just above the rear-end housing. Place the heat shield sleeve over return line and reconnect it to the canister. NOTE: Since fuel lines contain harmful vapors, this procedure should be done in a well ventilated area clear of any open flames or extreme heat. Safety glasses should also be worn when performing this action. 2. Using the supplied 10mm bolts, lock washers, and flat washers from the kit, install the I-pipe assembly #25- 3285 placing the hangers in the rubber isolators. 3. Using a 2-1/2” band clamp and hanger clamp assembly #23-4107 from the kit, install muffler #25-55742. NOTE: Only snug all clamps at this time for adjusment later. 4. Install overaxle pipe assembly #25-3286. WARNING!!! Exhaust gas contains carbon monoxide, a deadly invisible gas. Correct any leaks before driving! IMPORTANT NOTE: Proper installation is the responsibility of the installer. Improper installation will void warranty and may result in poor performance and engine or vehicle damage. KIT CONTENTS Catalog #5716 Qty. Part # Description ❑1 25-3285 I-Pipe Assembly ❑1 25-3286 Overaxle Assembly ❑1 25-3298 Tailpipe Assembly ❑1 25-5582 Tailpipe Tip (Polished) ❑1 22-5721 Installation Kit ❑1 25-55742 Muffler 5. Using a 2-1/2” band clamp, install tailpipe assembly #25-3298 placing the hanger in the rubber isolator. 6. Using a 2-1/2” band clamp, install tailpipe tip #25- 5582. 7. Working from the front of the system to the rear, adjust, align, and tighten all the band clamps. Give adequate clearance for fuel lines, brake lines, electrical wiring, and the spare tire. Edelbrock Corporation, 2700 California St., Torrance, CA 90503 Tech Line: (800) 416-8628 Office: (310) 781-2222 E-Mail: [email protected] ®