Edge-Core Minipack-AS8000 Manuals

– 1 – Quick Start Guide Install Rack-Rails in a 19-inch Rack The chassis requires L-shaped rack-rails (ordered separately) to first be installed in an 19-inch rack. Use the rack alignment templates to install rack-rails at the correct locations in the rack allowing for the height of the chassis (4RU). Three templates per rack post are required for the full rack height. It is recommended to use a total of 12 templates, three on each rack post. Note that the magnetic templates can be reused. 1. Align the cable-management T-pin on the rails with the Minipack numbers on the templates. The Minipack numbers are color coded for each template position on a rack post; green (bottom), orange (middle), and blue (top). a. Using Screw-Type Rack-Rails 1. Use two #12-24-16L rack screws to secure each rack-rail to the front post of the rack. 2. Adjust the length of the rack-rails to reach the rear post of the rack and secure them with two #12-24-16L rack screws on each side. b. Using Tool-Less Rack-Rails 1. Push the latch button to lock each rack-rail to the front post of the rack. (Optionally use rack screws for added security.) 2. Adjust the length of the rack-rails to reach the rear post of the rack and push the latch button to lock them to the post. (Optionally use #12-24-16L rack screws for added security.) c. Using Adapters for 29-inch-Deep Racks 1. Use two #12-24-16L rack screws to secure each adapter to the rear post of the rack. 2. Attach the rack rails to the rack adapters. Warning: For a safe and reliable installation, use only the accessories and screws provided with the Minipack- AS8000. Use of other accessories and screws could result in damage to the unit. Any damages incurred by using unapproved accessories are not covered by the warranty. Avertissement: Pour une installation sûre et fiable, utilisez uniquement les accessoires et les vis fournies avec le Minipack-AS8000. L’utilisation d’autres accessoires et vis pourrait endommager l’appareil. Les dommages causés par l’utilisation d’accessoires non approuvés ne sont pas couverts par la garantie. Warning: The top of the enclosure is a hot surface. Do not touch! Avertissement: La surface du dessus du boîtier est brûlante. Ne pas la toucher! Caution: Install in a restricted access location. Attention: Installer dans un endroit d’accès restreint. 1 1 Bottom Middle Top 1 2 Front Post Rear Post 1 2 Front Post Rear Post 1 2 E082019-CS-R02 150200002142A 128-Port 100G Chassis Switch Minipack-AS8000 1. Minipack-AS8000 2. AC power cord retention clip (x4) 3. Power cord (x4) 4. Console Cable—RJ-45 to DB-9 5. Documentation—Quick Start Guide (this document) Package Contents 5 1 2 3 www.edge-core.com 4