Elkay EFP01-G-A Manuals

ELKAY Pre-Filtration Sediment Filter EFP01-G-A Please read all instructions, specifications, and precautions before installing and using your water filter system. Page 1 1000003998 (Rev A - 05/2017) PARTS LIST • Filter Assembly • G1 Brass Nut (2) • G3/4 Brass Connector (2) • Rubber Washer (2) • 12.5mm I.D. PVC Drain Tube (300mm) • 150mm Cable Tie • 29.5mm ID PE Drain Tube (1.2m) • Hose Clamp • 3V Lithium Battery • Manual SPECIFICATIONS Rated operating pressure 0.1-0.4Mpa Rated service flow 50L/min at 0.2MPa Rated ambient temperature 4-40°C Rated operating temperature 5-38°C Ambient Humidity 90% Max Cable Tie P.E. Drain Tube Battery Hose Clamp Brass Nut Brass Connector Rubber Washer PVC Drain Tube Page 2 1000003998 (Rev A - 05/2017) Notice Do not use with water that is microbiologically unsafe or of unknown quality. Filter housing must be protected against freezing temperatures, frost, snow, sleet, and ice. Exposure to these elements can produce cracks and product failures. Turn off water supply if it must be left unattended for an extended period of time. • For cold water use only. Do not use on hot water line. • Make certain that installation complies with all state and local laws and regulations. • If the actual pressure is higher than or lower than the operating range, a booster pump or reducing value should be mounted, to ensure normal operation of the equipment. • Designed for residential use only. • The filter should be installed by a trained professional. Caution Caution 140mm 318mm 264mm 95mm Page 3 1000003998 (Rev A - 05/2017) Turn off the water supply to the home and setup the piping to match the diagram below. Clean all pipes and connections before continuing to the installation. Note: The filter can be used with the inlet on the right or left side. All images in the manual show the inlet on the left for reference. Before Installation Ball Valve Water Meter Floor Drain Floor X>220mm (Distance between pipe center and upper barrier) X>65mm (Distance between pipeline and wall) X=180±5mm (Distance between inlet/outlet) X<1200mm (Distance between inlet/outlet center and floor drain) X>350mm (Distance between pipeline and wall) Page 4 1000003998 (Rev A - 05/2017)