EMC CX3-10 Manuals

1 This document explains how to install CX3-series hardware in cabinets that conform to the National Electrical Manufacturer’s Association (NEMA) standards for 19-inch cabinets (in which the left and right mounting channels are 19 inches apart). It covers mounting hardware for SPS, SPE3, and DAE3P components, and describes how to cable the system to AC power and set up the back-end (disk I/O) bus. In most cases, the illustrations and examples refer to standard cabinets that are 40U tall. Topics are: ◆ Device placement requirements......................................................... 1 ◆ Device height requirements................................................................ 5 ◆ Power requirements............................................................................. 4 ◆ Installing a 1U storage processor enclosure (SPE3) in a cabinet.... 8 ◆ Installing a 1U SPS tray and SPS units in a cabinet....................... 13 ◆ Installing a 3U disk enclosure (DAE3P) in a cabinet..................... 20 ◆ Setting up an installed storage system............................................ 28 Note: Instructions for adding switches to a storage system are included in the device-specific documentation that accompanies the switch. Device placement requirements This document provides the steps required to install rails and enclosures in both EMC and non-EMC cabinets. Unless otherwise specified, the illustrations depict the 40U-C cabinet. EMC Rails and Enclosures (CX3-10 Class and CX3-20 Class Storage Systems) Field Installation Guide P/N 300-004-546 REV A03 July 20, 2007