Endon Studio Plug-in Wall Light Manuals

Studio Plug-in Wall Light Safety Warnings INSTRUCTION MANUAL • This product is only suitable for connection to a 240V~50Hz supply in accordance with current IEE wiring regulations. It is for indoor use only, and not suitable for a bathroom location. • This fitting is a Class II, Double Insulated product and does not require an Earth. Live or Neutral must not be connected to Earth. • Do not plug into the mains until your lamp is fully assembled. • Never fit bulbs of a higher wattage than those specified on the label, as these may damage the fitting. • The lamp must be protected by a 3 amp fuse in the mains plug. • If the mains cable becomes damaged it must only be replaced by a technically competent, qualified person. • If you are in any doubt about your competence please consult a qualified electrician. • This product contains delicate parts – take care during handling and maintenance to avoid breakage. • If any modification is made it will invalidate the warranty and may render the product unsafe Endon Lighting, LS9 0SE Assembly/ User Instructions Before you start Please read these instructions carefully before fitting and retain for reference. Check the packaging and make sure that you have all the required parts. Follow each assembly step in order to prevent incorrect assembly. Ensure that the product is fully assembled as illustrated before use. These assembly diagrams are intended as a guide – if in doubt consult a qualified electrician. Care Information Allow 10 minutes to cool before replacing, adjusting or cleaning. Clean with a dry cloth only. Do not use liquid or abrasive cleaners on this product. 79382 Studio W 20190613 Class II Plug Wiring Diagram E L N FUSE Fuse (3 AMP) Blue (Neutral) Brown (Live) The Light pack contains: Light fitting Fixing pack. The following tools may be required: Selection of cross and flat head screwdrivers. Electric drill and assorted drill bits. 1. Do not attempt to plug in or use this product until it has been fully assembled. Disconnect from mains during assembly or maintenance. 2. Decide of the position of this light fitting.. Use the backplate (1) as a template to mark the screw holes. Make the screw holes and secure to the wall with appropriate screw fixings (2). 3. Install the bulb (3). Do not install a bulb with a greater wattage or different shape than specified on the label. IMPORTANT: Children can become entangled in loose cable. Ensure excessive loops of cable are secured against the wall using suitable fittings, such as cable clips(not supplied). Do not use this product in children’s bedrooms. 4. Plug in, and operate the lampholder switch (4) to turn your lamp on. If your lamp will not illuminate, please check the bulb, the 3 amp fuse in the plug and ultimately check the relevant fuse in your Fuse Box. If unsuccessful please consult your Retailer.