ES-Key 1Touch 1200-04-00-CL1 Manuals

1Touch® switch - Quick Manual 1Touch® switch Quick Manual P/N 121693 REV A 5-19-2011 WIRING The 1Touch has one 6-pin Deutsch connector. Mating connector: Deutsch DT06-6S Mating sockets: Deutsch 0462-201-16141 Gold mating sockets: Deutsch 0462-201-1631 (* for CAN connections) Recommended wire gage: 16-20 AWG Wedge lock: W6S PIN CIRCUIT DESCRIPTION 1 SYS POWER (INPUT) – battery voltage (+9VDC…+32VDC) 2 SYS GROUND (INPUT) – battery ground 3 DIM INPUT (INPUT) – Configurable, analog or digital (ground to battery voltage) 4 CAN HIGH (DATA) – SAE J1939 CAN 2.0B, 250Kbits/s * 5 CAN LOW (DATA) – SAE J1939 CAN 2.0B, 250Kbits/s * 6 CAN SHIELD (DATA) – SAE J1939 CAN 2.0B, 250Kbits/s * SWITCH CAP INSTALLATION The 1Touch switch caps and labels are easily installed with no special tools required. The switch labels must be custom created. Consult the full manual for detailed information about the label. 1. Adhere the switch label to the rubber switch pad. Take special care to place the label with proper orientation. 2. Place one corner of the switch cap into the corner of the switch opening. 3. Press the switch cap’s other corner firmly into place using finger pressure. ENABLING PASSWORDS If more than 60 seconds has elapsed since the 1Touch switch was powered you must enter the ENABLE password: 1101 1011. The panel’s switch backlighting will blink once to indicate the password has been accepted. Standard password entry is now enabled for the next 60 seconds. ADDRESSING The 1Touch switch’s address may be set by entering the following password: 1001 0010. Switches 0 and 1 are now lit and all other switches are OFF. The red LED bar graph indicates the current address (see graphic below). Press switch 1 to decrease the address value. Press switch 0 to increase the address value. Press any other switch to save the address and resume normal operation. LOADING DEFAULTS To load the 1Touch’s defaults, enter the password: 1001 1001. This sets all of the switch types to bi-stable, address to 0, device type set to 5, initial power states to OFF, LED indicator controlled internally, and network mode set to ES-Key.