ESP APWIFIDS2 Manuals

x 1 Power Adapter DC Power Cable x 1 Black Red Dry/Wet Contact Cable x 2 Black Black Screw Pack x 1 Screw Pack x 1 x 1 Quick Start Guide Door Station & MicroSD x 1 Wall-Bracket x 1 HARDWARE OVERVIEW I/O Pin Connector 1.B2/B1: Dry Contact I/O for door lock 2. V-/V+: Power Input I/O* 3. RD+/RD-/TD+/TD-: Ethernet Cable I/O* 4. C2/C1: Dry Contact I/O for door chime Reset Button Memory Card Slot Push Button Microphone Light sensor *Power input jack can be safely connected with DC 9~48V power cable in any polarity. AC power input not supported. *Ethernet cable not included in the package. Full HD Camera Speaker 3 1. Fasten the wall-mount bracket to the wall by using 2pcs screws provided. 2. Connect power cable to the power input I/O pins by through the water-resistant cover. 3. Place the device on the wall-mount bracket. 4. Apply power to the device 1. The SD card will be pre-installed, if upgrading the SD card: 2. Slide the metal housing down and camera up to seperate the camera with back cover. 3. Remove the rubber cover of the SD Card slot on the left side of the camera. 4. Insert the SD Card and put back the rubber cover. INSTALLATION 2 1 3 4 SD Note: Battery AA 1.5V x 3 x 1 Door Chime 4 2 1 QUICK START GUIDE APWIFIDS2 APWIFIDSBLK2 INSTALLATION OVERVIEW Prior to installation, please ensure that a strong and stable Wi-Fi signal can be achieved at the installation position. A 2.4GHz Wi-Fi connection is required For additional guidance refer to the notes in the back of this guide. Power cable Water-resistant cover 1 2 4. After supplying power, the boot up process will begin (around 2 minutes), the push button LED will flash once the boot up process is complete and registration ready (check connectors and power source if red LED do not come on). CONTENT

Remote View Door Phone Installation and Operating Instructions PLEASE READ THESE INSTRUCTIONS CAREFULLY BEFORE USING THIS PRODUCT AND KEEP THIS MANUAL FOR FUTURE REFERENCE.