Fast 1000 Series Manuals

User Guide FAST TECHNOLOGY Digital Torque Meter and Rotary Torque Sensor Set Series 1000 111 Lb-Ft (150 Nm) Contents ..............................................................1 Battery Installation ...............................................1 Safety Rules ........................................................1 Overview of Meter Button Functions....................1 Operation Cautions..............................................2 Operation Procedures..........................................2 Continuous Track Mode.......................................2 Peak Mode ..........................................................2 Target Mode ........................................................2 Changing Units between Lb-Ft and Nm...............3 Power Off.............................................................3 Low Battery Indicator...........................................3 Important Suggestions.........................................3 Care and Maintenance ........................................3 Error Codes .........................................................3 Meter and Sensor Set Specifications...................3 Contents Digital Torque Meter Rotary Torque Sensor (1) ea. – ½” square drive 111 Lb-Ft (150 Nm) Torque Sensor (1) ea. – Digital Torque Meter with Protective Boot Battery Installation The battery is installed in a compartment accessible from the back of the unit. Remove the unit from the Boot, loosen the screw and remove the battery cover by pulling straight back. Insert the 9 volt battery and re-install the battery holder panel as shown below then re-secure the screw. Figure A Figure B Figure C Figure A – Grip the boot at the top and stretch over the meter Figure B – Place the battery in the cover as indicated Figure C - Insert by placing one side into the opening and guiding the two outside clips (white arrows) into the opposite side. Safety Rules 1) STUDY THIS USER GUIDE CAREFULLY BEFORE ATTEMPTING TO OPERATE THIS INSTRUMENT. 2) Always wear eye protection when using this product. 3) Never apply more torque than the maximum rated load – 111LB-Ft (150Nm). 4) DO NOT use with impulse, impact or any motor driven drivers. This sensor is designed for torquing fasteners manually only. 5) Over-tightened or defective fasteners and sockets may suddenly fail. Ratchets, sockets and flex handles that are improperly engaged, worn out, damaged, or used beyond rated capacities may slip or break. Warning: To prevent injury, keep proper footing and balance at all times. Do not use the sensor system in places where the user may slip or fall around operating machinery. 6) DO NOT overload any tools used with this product. The sensor system will not prevent user from applying more torque than set - it is not a torque limiting tool. 7) Use caution when reading the display and tightening a joint at the same time. This may result in loss of control. 8) The battery is the only user serviceable part inside the meter (see battery installation procedure). There are no user serviceable parts inside the sensor. Disassembly of either component will result in loss of accuracy and will void the warranty. Overview of Meter Button Functions Press and hold to switch Target Mode On or Off Press and hold to switch Peak Mode On or Off Press to Power On Press and hold to Power Off Press to Zero display Press to Erase Peak Double Press to Erase Peak and Zero display Press and hold both ARROW buttons (rs) to switch between Lb-Ft and Nm Press arrow key to view and adjust Target Alarm Value