Fiber Tronix FT-FOTR-16VD-ST-S Manuals

v1.0 4/5/11 1 INSTALLATION MANUAL FT-FOTR-16VD-ST-S 16-Channel Digital Duplex Baseband Video Transmitter and Receiver With Reverse Data Transmission for PTZ Cameras v1.0 4/5/11 2 PACKAGE CONTENTS This package contains: One each FT-FOTR-16VD-ST-S 16-channel baseband video transmitter and receiver Two 5VDC power supplies One installation manual PRODUCT DESCRIPTION The FT-FOTR-16VD-ST-S fiber optic transmitter/receiver supports the transmission of sixteen baseband video channels and a single reverse data signal over one strand of single-mode fiber optic cable. This product is compatible with all NTSC and PAL video signals. Power, optical signal, video signal and data signal are easily inspected through LED indicators directly on the units. The transmitter and receiver combination supports transmission distances for optical loss budgets of less than 18 dB. SPECIFICATIONS FT-FOTR-16VD-ST-S Specifications (Typical) 1. Optical Wavelength 1310nm / 1550nm 2. Fiber Type Single-mode 9/125µm 3. Maximum Link Distance 12.5 miles 4. Connector Simplex ST 5. Acceptable Loss Budget 18 dB 6. Number of Video Inputs 16 7. Video Connector BNC Female 8. Transmitter Input Impedance 75Ω unbalanced 9. Receiver Output Impedance 75Ω unbalanced 10. Video Bandwidth per Channel 0Hz – 6.5MHz 11. Video SNR >60 dB 12. Differential Gain <1% 13. Differential Phase <1° 14. Tilt <1% 15. Data Rate 0 – 300Kbps 16. Data Connector Terminal Block 17. Data Interface RS485, RS422 or RS232 18. Baud Rate Per Channel 0 – 100Kbps 19. Bit Error Rate <10-9 20. Power Supply 5VDC 21. Power Consumption <10W 22. Operating Relative Humidity 0 – 95% non-condensing 23. Operating Temperature 14F – 122F 24. Dimensions 9.1”x8.2”x2.2” per unit 25. Weight 2.6 lb. per unit v1.0 4/5/11 3 INSTALLATION AND OPERATION CAUTION: To reduce the risk of electrical shock do not remove the cover or back of this unit. No user serviceable parts are inside. CAUTION: To prevent electric shocks and risk of fire hazards, do not use other than specified power source. 1. UNPACKING and HANDLING Each unit is shipped assembled and factory tested. Ensure that all accessories are removed from the container before discarding packing material 2. MECHANICAL INSPECTION Inspect the front and rear of the equipment for shipping damage. Make sure the equipment is clean, and no connectors are broken, damaged, or loose. If equipment appears to be damaged or defective please contact your distributor or Fibertronix at 1-610-429-1511 for assistance. 3. WIRING CONNECTIONS Transmitter Front and Rear Panels Data Tx Data Rx Power Optical Digital Video Optical System 6 7 8 14 15 16 5 13 1 2 3 4 9 10 11 12 Video Signal Indicators POWER CH1 CH9 CH10 CH11 CH14 CH12 CH13 CH15 CH16 CH2 CH3 CH4 CH5 CH6 CH7 CH8 OPTICAL Optical port （ST/PC） Power Input （DC5V） Video Input 1-16 ch A B Data G Data connector (Terminal Block) This symbol is intended to alert the user to the presence of important operating and maintenance (servicing) instructions. This symbol is intended to alert the user to the presence of “dangerous voltage” within the product’s enclosure that may be of sufficient magnitude to constitute a risk of electrical shock.