Fisher & Paykel IWL12-96154B Manuals

NOTE TOTHEINSTALLER Afteryou havefollowedthe procedureson thepreviouspages. Checkthefollowing. REMOVE TRANSIT BO'I'rOM PACKER Bottom packer MUST be removed from the base of the washer, before the basket packer is removed. LEVELING Make sure washer is level and four rubber inserts are properly installed. ADJUSTABLE FEET _m RUBBER INSERT _'_ DRAIN HOSE PULL HOSE THROUGH GUIDE m 3/4" (20mm) The drain hoseguide MUST be fitted to the drain hose and should not extend more than 3/4" (20mm) from the end of the guide. Place the drain hose in tub or standpipe. GROUNDING MUST be properly grounded to conform to local codes and ordinances. WARNING: Improperconnection of equipment-groundingconductor can resultin a riskof electricshock. Check with a qualifiedelectricianor servicemanif you are indoubt as to whether the appliance is properly grounded. INLETHOSE CONNECTIONS Faucet end of hose Filter end must be connected to faucet. Washer end of hose. OPERATION 1.Turnfaucets on. Check for leaks, noise, vibration, correct water temperatures and proper operation in spin. 2.Turn hotand cold water faucetsoff and instructcustomer to do the same when washer is not in use. 3. Give customer the Use & Care Book and Installation Instructions. INSTALLATION REQUIREMENTS LOCATION Washer must be installed on firm flooring to minimize vibration during spin cycles. Concrete flooring is best, but wood base is sufficient providing floor support meets FHA standards. Washer should not be installed on rugs or exposed to the weather. PLUMBING Water Temperature Your cold water should not exceed 95°F (35°C) or your hot water exceed 150°F (65°C). Temperaturesabove this may damage your washer. Shut off valves Both hot and cold shut-off valves (faucets) should be available in laundry area. Drain Water may be drained into a standpipe or set tub. The standpipe must be 11/2" (38mm) minimum inside diameter and must be open to the atmosphere. ELECTRICAL This appliance must be supplied with 110V-120V, 60Hz, and connected to an individual, properly grounded branch circuit, protected by a 15 or 20 amp circuit breaker or time delay fuse. SPECIFICATIONS Lid Clearance Washer end of hose _ Faucet end of hose Standpipe Height 33 1/2" to 78" HEIGHT ! I Allowfo_ adjustablee// DEPTH DIMENSIONS WIDTH Inlet water pressure Max 150 psi (1MPa) Min 3 psi (20kPa) MODEL All models DEPTH 251/2" (650mm) WIDTH 251/2" (650mm) HEIGHT to top of console 401/2 "- 411/2" (1020-1050mm) HEIGHT LID OPEN 551/2 "- 561/2" (1410-1440mm) Specification subject to change without notice P/N 420264A Specificationsubject to change without notice